wall light motion sensor
Which charging plug is best to use for charging? Is there a voltage limit?
Please use a 5V/2A or 5V/1A charging plug for charging. Do not use a plug with a voltage higher than 5V DC, otherwise the circuit board inside the lamp will burn out.
What is the range of the sensor? How many seconds does it take to turn off?
The motion senso only activates when movement is detected within a 5-meter radius. It turns off after approximately 35 seconds of inactivity.
Can the wall light be used as main lighting?
The light output of our wall light is 600 lumens. The light is not particularly bright, so it is recommended to use it as ambient or mood lighting.
How long can the induction mode last after a full charge?
After a full charge, the 5000mAh battery-operated wall light can last 1 to 2 months in motion sensor mode, depending on usage frequency.
How to use the remote control? What is its range?
To use the remote control, you need to set the switch to the "II" position. The detection angle is 120° and the detection distance is 3–5 meters (this may vary with temperature).

wall light motion sensor
Which charging plug is best to use for charging? Is there a voltage limit?
Please use a 5V/2A or 5V/1A charging plug for charging. Do not use a plug with a voltage higher than 5V DC, otherwise the circuit board inside the lamp will burn out.
What is the range of the sensor? How many seconds does it take to turn off?
The motion senso only activates when movement is detected within a 5-meter radius. It turns off after approximately 35 seconds of inactivity.
Can the wall light be used as main lighting?
The light output of our wall light is 600 lumens. The light is not particularly bright, so it is recommended to use it as ambient or mood lighting.
How long can the induction mode last after a full charge?
After a full charge, the 5000mAh battery-operated wall light can last 1 to 2 months in motion sensor mode, depending on usage frequency.
How to use the remote control? What is its range?
To use the remote control, you need to set the switch to the "II" position. The detection angle is 120° and the detection distance is 3–5 meters (this may vary with temperature).


















































