DIGITEN Millivolt valve Gas fireplace remote control Kit WTC401 Introduction to the Features of the Remote Control Previous page Next page A thermostat designed for millivolt valve gas fireplaces WIRING MILLIVOLT VALVE Connect the two 18-gauge stranded or solid wires of the Remote receiver box to the Milivolt gas valveat the TH & TH/TP teminals on the temminal block. ELECTRONIC SPARK MODULE Connect a 24VAC transformer in series to the TR (transformer) terminal on the ELECTRONIC MODULE Replace On/Off Switch Replacing an existing wall / manual On/Off switch or room thermostat with remote receiver. Millivolt valve gas fireplace Check compatibility by identifying your valve type.
Our remotes work with Millivolt systemslook for the TH & TH/TP terminals on the valve.
Receiver Introduction ON: Slide the switch to the ON; the system will remain ON all the time. The remote transmitter is disabled.
AUTO: Slide the switch to the AUTO. The system will only operate by receiving commands from the remote transmitter.
OFF: Slide the switch to the OFF the system will remain OFF all the time Remote control The remote control is equipped with a built-in temperature sensing chip to control the millivolt valve gas fireplace, keeping the ambient temperature within the range you need What's in the packaging box Remote Transmitter Receiver Box Wall Mount Cover Plate (white) Plug-in Wiring Assembly (22 inch), Screws, Installation & Instruction Battery is needed
Warm reminder: For this gas fireplac