Bamboo Lab H2D,H2S,X2D,P2S Hotend Kit, Hardened Steel 0.8mm Nozzle Precise Print Head, Consistent Extrusion Heating Block, Extruder Hot End Accessory for Bambu H2C Left, H2 Series 3D Printer

Quick Swap H2 Series Hotend for H2D, H2S, H2C Left, P2S, X2DThe unique design of the H2 Series hotend heating assembly allows for easy separation of the thermal and electronic components of the hotend. Simply release the latch for quick and effortless hotend removal and installation. Wide CompatibilityThis extruder hot end kit is compatible with the H2 series of 3D printers, including the H2S, H2D, H2C left, P2S, and X2D. 0.8 mm Nozzle - Faster Print SpeedThe larger diameter pushes out more filament per second, leading to quicker print speeds.

Factory Pre-Tested Quality AssuranceTo ensure zero clogs and flawless extrusion right out of the box, every H2 Series hotend goes through a rigorous factory calibration test using high-temperature test filament. You may see a small amount of white or colored residue inside the nozzle tip. This is NOT a defect, grease, or a used item. It is a mark of quality control. Simply heat the nozzle to your printing temperature and purge the filament; it will clear within the first few seconds of use, leaving you with a perfectly clean, high-performance hotend.

Note 1: Filaments with carbon fiber, glass fiber, metal, or other inorganic particles are likely to clog a 0.2 mm nozzle.
Note 2: For filaments containing carbon fiber or glass fiber, it is strongly advised to use a hardened steel 0.6 mm nozzle to reduce the risk of clogging and wear.
Note 3: Bamboo PLA-CF and Bamboo PETG-CF have been thoroughly tested and shown to have a low clogging risk when printed with a hardened steel 0.4 mm nozzle, while also delivering higher print quality