5 Pack Panel Mount 24Pin USB 2.0 Type-C Female Socket with PCB Breakout Board, DIY OEM USB-C Panel Mount Connector Module for Custom Enclosure Equipment Prototyping

This 5-pack Type-C female panel mount connector comes with pre-soldered 24pin USB-C socket and green breakout PCB, specially made for DIY electronic production, OEM equipment assembly and circuit prototype debugging.

Built to USB 2.0 specification, it supports maximum 480Mbps data transfer speed and 5V power supply output. The PCB reserves four clear solder terminals labeled VCC, D+, D-, GND, which greatly simplifies manual wiring without complex soldering to tiny 24 internal pins of the Type-C socket.

The metal flange with two mounting screw holes enables firm installation on aluminum chassis, instrument panels, project boxes and custom device shells. The reinforced metal shell provides extra strain relief to prevent port damage caused by frequent plugging and cable pulling. All contact pins adopt gold-plated process to reduce contact resistance and avoid signal dropouts during long-term continuous use.

Plug-and-play wiring design, no extra driver needed. Widely applicable to single-board computers, industrial control equipment, custom audio devices, portable power banks, test measuring instruments and homemade peripheral hardware. The 5-piece bulk pack satisfies simultaneous multi-project production and equipment replacement demands for electronic hobbyists, maintenance technicians and small OEM factories.