Ubiquiti 2.4GHz 8.5dB NanoStation Outdoor 150Mbps CPE (LocoM2)

NanoStation Loco M2 is a very compact outdoor equipment, which integrates 2 antennas (MIMO) of 8 dBi gain for the 2.4 GHz band. The actual transfer speed of the equipment is up to 150 Mbps. Another great advantage is the high transfer speed of the 802.11 n standard, thanks to the TDMA Time Division Multiplexing technology, it allows more than 300 clients to be connected to the equipment. This model has a low latency. Compared to the Nanostation M predecessors, the Nano Loco M2 has a processor with a higher clock frequency of 400 MHz and more memory.

Simple and transparent administration website. Some examples of possible configurations can be: AP, client or WDS mode. Traffic Shaping. QoS Transparent bridge or routing between WAN and LAN, with NAT or without NAT. Specific LED to indicate the strength of the signal. Output power 23 dBm. The equipment supports IPv6 in bridge mode and WDS. Includes the 24V PoE injector needed for power, the injector has a reset button, you can use this button to change the device to the recovery mode and upload the firmware via TFTP. Another advantage is that it supports PoE on the secondary ethernet port, which allows it to power another device. This feature can be disabled through software.
Important information about compatibility: This device uses the new AirOS V firmware version. For this reason, the device may not be fully compatible with other radio devices. The AirOS system is continuously improving, so it is recommended to