X10 Powerline Command Repeater (PLC01)

Make sure your X10 powerline signals get to their destinations reliably by adding the X10 Powerline Command Repeater to your system. The module simply plugs into an outlet and immediately begins repeating any X10 signals that pass through it over the powerline, extending signal range. Repeats X10 powerline signals to extend range Plugs into any standard power outlet Built-in outlet on bottom for other plug-ins
Because the X10 Powerline Command Repeater plugs into an outlet, it features a built-in pass-through outlet at the bottom (not X10 controlled), so you dont lose a power outlet. The repeater should be installed in the approximate center between your X10 RF transmitters and receivers.
NOTE: The outlet on the bottom of the module is not X10 controlled. It serves as a traditional pass-through power outlet only.

Technical

Details

MPN: PLC01
Color: White
Control: Active repeating of X10 powerline commands
Power Requirements: 120 VAC, 60Hz, 5A
Environmental Conditions: Indoor use only
Dimensions: 2.94 (L) x 2.06 (W) x 1.3 (D) inches
Warranty: 2 Years