Starlink Gen 3 Wall Mount Kit for Standard 4/4X V4 Dish, Heavy-Duty Steel

Permanently mount your Starlink dish on a wall, eave, or fascia with a Starlink Gen 3 wall mount kit built for the long haul and built to install without leaks. INSTALLS WITHOUT A LEAKDrilling a hole through your exterior wall for the Starlink cable is the part of the installation buyers worry about most. This Starlink wall mount kit ships with a plastic sealing plug that closes the RJ45 cable through-wall hole, plus an internal cable routing path that runs the Starlink cable hidden through the pipe adapter, both poles, and the mount base so the cable stays weatherproof, UV-protected, and out of sight from dish to wall.

ENGINEERED TO OUTLAST THE DISH IN WINDThe Starlink Gen 3 Standard dish is rated by Starlink for 60mph winds. This Starlink mount is built to keep holding well past that point: - 1.8 mm reinforced steel mount base plate (up from the 1.5 mm typical on competing mounts)- 40mm diameter, 2mm wall curved lower pipe- 36mm diameter, 1.5 mm wall upper pipe- Powder-coated steel construction with 2-year anti-rust finish- All anchor bolts, screws, and fasteners are stainless steel no rust streaks on your sidingNO-TOOL ADAPTER MOUNTING, NO WOBBLEThree hand-tightened bolts clamp the Gen 3 pipe adapter solid to the pole no wrench, no socket set required. After tightening, the dish stays locked in place without the play and wobble that is common across other Gen 3 mounts. 21" REACH WITH FULL ANGLE ADJUSTMENT21 inches of total arm length, with pitch adjustment at the mount base and full 360 azimuth rotation via the pole. Enough clearance for typical residential eaves and fascia, and enough adjustment to keep the dish from contacting the wall during aiming. HARDWARE FOR ANY WALLShips with 6 stainless steel anchor bolts for concrete and brick walls (5cm effective embedment) AND 6 stainless steel self-tapping screws for wood walls, fascia, soffit, and eaves. Includes a hardboard drill template for accurate hole layout, and a Quick Start installation guide.

COMPATIBILITYFits: Starlink Standard, Gen 3 (V3), Standard 4, Standard 4X, V4 dish all share the same snap-in adapter interface.
Does NOT fit: Starlink Mini, Starlink Standard Actuated (Gen 2 rectangular), Flat High Performance, Performance Gen 3. WHAT'S IN THE BOXPipe adapter (Gen 3), curved lower pipe, extended upper pipe, mount base, 6 stainless steel concrete anchor bolts, 6 stainless steel self-tapping wood screws, RJ45 cable through-wall sealing plug, hardboard drill template, Quick Start Guide.