ELECNEXUS PCIe 5.0 Riser Cable 100mm Vertical GPU Mount RTX 5090/5080

FULL PCIe 5.0 x16 BANDWIDTH, NEAR-ZERO
SIGNAL LOSS: Unleash full 128GB/s (64GT/s per direction 2x the bandwidth of PCIe 4.0 ) on a CPU-direct PCIe 5.0 x16 slot. Controlled-impedance traces and tuned shielding keep the signal eye clean under sustained 4K/8K gaming and rendering no speed drops, no stuttering. ^^ 78W
DEDICATED POWER FOR FLAGSHIP GPUS: A 40-pin connector with dedicated 12V and 3.3V power paths keeps power stable for high-draw cards like the RTX 5090/5080, even under peak load and overclocking. ^^ ULTRA-FLEXIBLE TPE, BENDS 90/180
WITHOUT KINKING: The soft 29AWG TPE cable routes cleanly around tight case corners and bends 90 or 180 without kinking. It frees the motherboard slot from lateral stress, lowering bent-slot and poor-contact risk. ^^ TRIPLE EMI SHIELDING & 6-LAYER
GOLD-PLATED PCB: Triple protection an independent metal shield, foil-wrapped signal pairs, and tinned copper braiding blocks EMI from CPU coolers, PSUs, and RGB controllers. The thickened 6-layer PCB resists bending fatigue, while 5m gold-plated contacts lower resistance and resist oxidation for lasting, reliable connections. ^^ BROAD GPU COMPATIBILITY & EASY SETUP: Works with RTX 5090, 5080, 5070, 4090 and RX 9070 XT, 7900 XT, backward compatible with PCIe 4.0 / 3.0 for ITX, SFF, mid-tower, and open test-bench builds. Measure slot-to-GPU distance first and leave extra length for bends. Always power off and unplug before installing (no hot-swap), then seat both connectors until latched. If the GPU is not detected or the system won't boot, check connections and your BIOS/UEFI PCIe settings.