Meet Your Seller
AJMRTC MCP4725 12 Bit I2C IIC DAC Breakout Board, Digital to Analog Converter Module with Built-in EEPROM, Rail-to-Rail Analog Output for Arduino Raspberry Pi Electronic Experiment
- 1. MCP4725 single-channel 12-bit DAC chip, delivers high-precision digital-to-analog voltage conversion
- 2. Integrated non-volatile EEPROM, saves DAC configuration data and restores preset output after power cycle
- 3. Standard I2C IIC two-wire interface, supports fast communication speed, easy MCU control
- 4. Rail-to-rail buffered analog output, low noise and low offset voltage for stable signal performance
- 5. Wide working voltage 2.7V-5.5V, compatible with 3.3V and 5V mainboards for embedded projects
Any questions? Ask CelesteSM will help you find out quickly.
AJMRTC MCP4725 DAC breakout board is a widely used analog signal conversion module for makers, students and electronic engineers. It adopts the MCP4725 12-bit digital-to-analog converter chip, which converts digital signals from microcontrollers into smooth continuous analog voltage, much cleaner than simple PWM simulation. The built-in EEPROM can store your customized DAC parameters, so the module automatically loads the saved voltage setting once powered on, without sending control commands again. It uses the universal I2C communication bus, only requiring SDA and SCL signal lines to connect with Arduino, Raspberry Pi, STM32 and other main control boards. The onboard buffer amplifier supports rail-to-rail output, covering nearly the full supply voltage range while keeping low noise and tiny offset error. It also supports power-down mode to cut power consumption for battery-powered portable devices. This module fits voltage calibration, signal generator, servo analog control, lighting dimming, sensor simulation and circuit teaching experiments. Pin header is pre-soldered for quick plug-in on breadboards, convenient for rapid prototype verification.
Specifications
Brand: AJMRTC
Chip Model: MCP4725
Resolution: 12-bit
Channel: Single Channel DAC
Communication Interface: I2C (IIC)
Onboard Memory: Integrated EEPROM, Non-Volatile Storage
Output Type: Rail-to-Rail Buffered Analog Voltage Output
Working Voltage: 2.7V ~ 5.5V
Compatible Logic Level: 3.3V / 5V
I2C Speed: Up to 400kHz Fast Mode
Working Current: Low power consumption, supports power saving shutdown mode
Application: Arduino, Raspberry Pi, STM32, Analog Signal Generation, Electronic DIY, Laboratory Test
Warranty & Returns
Warranty, Returns, And Additional Information
Warranty
- Please contact the Seller directly for warranty information. Warranty information may also be found on the Manufacturer's website.
- CONTACT
Return Policies
- Return for refund within: 30 days
- Return for replacement within: non-replaceable
- This item is covered by ConnectFlow USA Return Policy
Manufacturer Contact Info
- For a directory of all our manufacturers, please click below.
- Manufacturers Directory









