Silverstone All Black Sleeved 1-3 PWM Fan Splitter Cable 100 mm (CPF02)

Pros: Does the job.

Cons: Isn't magic.

Overall Review: A little upset about the lack of magic, but not enough to knock an egg off.

Pros: -Turn 1 motherboard fan header into 3. -Excellent for cable management. -Black color blends well. -PWN.

Cons: -Cannot independently control the 3 fans connected, but this should be expected as they are all sourced to 1 fan header.

Overall Review: While you cannot control the 3 independently, the 3 being sourced to a motherboard fan header means you can at least have them controlled collectively at one speed, either by manual software/bios control of automatically by your board chipset. Before I switched to these, 4 of my case fans were powered via molex directly from my power supply, meaning they were on full RPM. Now instead of listening to a vacuum, I only hear the soothing hum of appropriately managed fans.

Pros: Is what it is.

Cons: None

Overall Review: Be sure your single fan header can output enough juice to run three case fans. I had a complete motherboard failure immediately after switching to this part (from a 2 to 1 to this 3 to 1). I'm not sure what caused the failure but the timing was suspicious.

Pros: Braided Black Only a few bucks

Cons: None

Overall Review: Great in the meantime. Now i can automatically control 3 fans from one 3pin header with free software called "Speedfan". My led fans are 3 pin so at high speed light is brighter and dim low speed and when fan not spinning no light. Will be getting corsair LL fans soon to fit my 460x case (comes with Lighting Node).

Pros: This splitter does its job well, allows you to connect 3 fans on a single fan header - very useful for Mini-ITX boards. This header is made for PWM fans, but I can confirm it works well with voltage regulated fans. I have 3 of them on my system, connected on one single hybrid header that can control via voltage (or PWM if need be). It's all black and stays out of sight, unlike those yellow and red cables you'll see elsewhere, that's a big plus for me.

Cons: Relatively short, so keep this in mind. It was fine for me, but YMMV.

Pros: sooo helpful for mini atx boards that only have one cpu fan header and one case fan header.

Cons: none so far

Pros: - Cables show no ketchup and mustard colours. Its clean black. - Cables are malleable enough for cable management.

Cons: Nothing was really wrong with this cable. Only possible improvement I can think of is perhaps smaller plastic ends

Overall Review: As I was wondering before I bought it, 1 of the endings has 4 pins. That is the one which reads the speed. The other fans will spin at the same speed as it, so you must occupy that slot first.

Pros: It works. Was perfect for adding fans to my small server case.

Cons: I am using it for fans in the front and on top on my case which was a pain because of the way the fan plugs are connected to the power connectors.

Overall Review: If all your fans are next to each other it wouldn't give you a problem. Once you get everything plugged in and sorted it's fine.