STEELMAN 18240 1/8-Inch Carbide Double Cut Burr for Tire Repair Dressing

One of the main steps in the Rubber Manufacturer's Association tire repair procedure for pneumatic tires is to make sure the tire injury has been cleaned out in preparation for a plug stem or plug stem patch. The STEELMAN 18240 1/8-Inch Carbide Double Cut Burr for Tire Repair Dressing is designed for that specific step of tire repair. When used with the STEELMAN SLP9213 3/8-Inch adapter and fitted to a low speed tire buffer tool it allows you to create a clean, smooth, and uniform repair channel through tire rubber and the embedded steel belts without the risk of friction scorching that could further weaken the tire.

The double cut design allows this cutter to remove material on both the insertion and removal parts of each stroke speeding up total repair time. The durable carbide steel bur features flats along the shaft ensure that when fitted into the adapter, the set screw has secure purchase and will keep the bur from being seized by the tire material and ceasing to turn.

REMOVE DEBRIS - Used to remove debris and clean out the channel of damage caused during a tire puncture

CREATE A UNIFORM CHANNEL - Creates a clean, smooth, and uniform 1/8-inch wide channel for a better seal when using tire repair plug stems and stem patches

USE WITH ADAPTER - Designed to be used in partner with the STEELMAN SLP9213 3/8-inch drive adapter in a low speed buffer tool

DURABLE CARBIDE STEEL - The burr is made of durable carbide steel to stand up to hard use

DOUBLE CUT DESIGN - Double cut design of the burr tip allows it to cut on both insertion and removal strokes during tire repair

REPAIR TIRE INJURIES - Can be used to repair tire injuries up to 1/8-inch in diameter