Specifications: Comb power button & reset button on Power supply and HDD working status LED indicators w/ PMMA case for switch protection Covered self-adhesive in bottom for easy installation 2FT in cable length
Specifications: Main chip: NEC UPD720202 chipset
Have unused mini PCIe slot for PC expansion slot a 19-pin USB3.0 theoretical transfer rate up to 5Gbps, much higher than the USB2.0 480Mb / s, up to 10 times;
Backward compatible with USB2.0, USB1.1, USB1.0
Transfer rate: 5Gbps/ 480Mbps/ 12Mbps / 1.5Mbps
SATA to take power by the board, or you can into a small Molex 4PIN power. (To change, please contact customer service)
Built-in 19-pin can turn out two USB3.0 ports
Compliance with PCI-Express Specification Revision 2.0
Compliance with xHCI specification version 1.0
Compliance with USB3.0 SuperSpeed specification version 1.0
USB support hot swap function
Support Windows XP / 2003 / Vista / win7 / win8 / 2003 / linux, can provide LINUX drivers.
Note:
Mini PCI-E because without a 5V power supply, not directly to the USB-powered, so it can be inserted using the SATA power cabl...
Specifications: 1.Input ports: VGA, 3.5 mm audio, USB power port 2.Output ports: HDMI-compatible female 3.Dimensions: 66 x 55 x 20mm 4.Weight: 40g 5.Supported input resolutions (at 60Hz): 640x480, 800x600, 1024x768, 1280x720, 1600x1200, 1920x1080 pixels 6. BYPASS Converter, Output support HD 1080p, 1080i, 720P, 480i and other resolutions
Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board.
These heat sinks have profiles which are short enough to fit within standard Raspberry Pi cases.
Pure copper heatsink thermal conductivity up to 401w / mk,good idear for processor,CPU and GPU cooling,Tested to fit the Raspberry Pi CPU / SoC,reduce the risk of hardware failure due to overheating.
These heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips.
These heat sinks can be used with other devices such as the Beaglebone to cool processor, regulators, etc.
Installation Instructions:
-Make sure the chip modules are free from dirt and gre...
Specifications: Bus Type: PCI Express Mounting Type: Full Profile PCI slot cover Chipset: VIA VL805 Interface: 2x USB 3.0 Port Type-A & Internal USB 20pin header to 2x USB 3.0 floppy 3.5-inch front panel Data Transfer Rate: USB 3.0 - 5 Gbit/s Connector Type (s) 1 - PCI Express x1 Male Rear Ports: 2x USB 3.0 Port Type-A Female Front Ports: 2x USB 3.0 Port Type-A Female
Specifications: RJ45 8P/8C Female port gold-plated contacts Category 5e ANSI/TIA/EIA 568-C.2 performance T568A and T568B Labeling IDC modules (110 or Krone) with covers Compatible with 22-26 AWG Solid wire