PrimoChill Ice - Low-Conductive Computer Watercooling Fluid (32 oz.) - UV Brite Green

Step 1 - Prepping RadiatorsRadiators can often times be the most needed component for prepping. We recommend using our RadClean (not included) solution for a a clean and ready radiator.
Step 2 - Initial Cycling and Flushing Sys Prep (not included) is recommended to properly cycle your system and make sure all your components are clean of machinery oils, loose debris, and other substances that may kill your PC Ice.
Step 3 - Cleaning old fluid out System Reboot (not included) was created to pull old dyes and fluid out of existing PC builds. This is essential to use if you had any other previous fluids in your build that you plan to use PC Ice in.
Step 4 - Add your final PC ICEAfter going through all the proper prepping (follow our guide) you're ready to add your PC Ice!



Preparation We recommend a thorough cleaning of all tubing and system components prior to priming your system with ANY fluid. Flushing your system with Sys Prep (not included) is recommended to remove any particles as well as any residual that may exist from previous build or the tubing manufacturing process and balances PH level in your loop. This is the driving force behind the stability and vibrancy of your color. Every system is different and will have varying starting PH levels. The longer you run the SysPrep mixture in your system the better the results will be! Some systems are balanced after only a few hours while in rare cases others may take days to achieve this.
Low-Conductivity As with all Low-Conductive fluids, PC ICE can become conductive if it comes in contact with excessive dust or other fluids that may be conductive. The Low-Conductive aspect of PC Ice is used as a safety measure only. It is always a good idea to keep your system clean and free of dust, especially in a water cooled system. Recommend: Pre-treat your system with Sys Prep (not included) to achieve a clean loop and to ensure optimal non-conductive results.
Maintenance As with all custom loop water-cooling, continual maintenance and frequent inspection is required. ICE will need to be replaced every 6 months, depending on the complexity and conditions of your loop this time frame may vary.
Compatibility Use of this product with aluminum components (such as aluminum constructed radiators) is STRONGLY DISCOURAGED.PrimoChill will not support or replace fluids used with an aluminum radiator. Do not mix ANY additional additives, coolants or silver coils with ICE. This will change the formulation of ICE which can cause the fluid to solidify or break apart. Known incompatible radiators include but NOT limited to: Thermaltake RL Series - Radiators and EK Aluminum Kits.
Staining The use of any colored fluids WILL ABSOLUTELY stain your components in your cooling loop including rigid and flexible tubing, acrylic reservoirs, and blocks. Prolonged use will cause permanent staining of your components. Severity of staining will be based on the color. Use of this product is at your own risk. PrimoChill will not replace stained components.
Color Loss During the initial application of ICE, the product may change/lose its original color when added to your loop within the first 24-48 hours. This is a common, well known occurrence. If this happens to your system, immediately drain and flush it out with DI or Distilled water. Once the system has been drained and cleaned, refill your s