Question 1

I received a MB from a friend, but it has been years since I've done any computer building.  the manual states the size of the MB is "ATC Form Factor, 12" x 9.6" (30.5cm x 24.5cm), Will this case handle that motherboard?  It has high heatsink - I don't have the MB while writing this, but I'm guess it might be pushing 3.5" if not closer to 4".

Accepted Answer

yes that is a standard atx MB size and it will fit no problem. I have three of these cases and I love them. 2nd best case I have owned 
in quality and usefulness. Only problem to watch for is the magnets on the front door coming off (or out) of their little socket they sit in. Nothing a little glue didn't fix. Solid, very quiet, gull wings on both sides make access east to MB and the internal works. to be sure I just measured and there is 7+ inches clearance from MB to door. That fan wont be a problem. It is a heavy case, due to the well built structure. You will love it.

Question 2

There are no good pictures of the back of the case so i was wondering if there would be any issues with the i/o on the back or if any ATX motherboard should work?

Accepted Answer

I used an ATX server board and there was no problem.  It should fit any standard ATX board.

Question 3

There appears to be both an 80mm and 120mm in the front grill of the case.  What gives?

Accepted Answer

I assume you're talking about fans.  Here's what the spec says:

Cooling System
Front: 1 X 120mm LED fan (optional)
Side: Left: 1 x 120mm fan (optional)/ Right: 1 x 80mm fan (optional)
Back: 1 x 120mm fan
Top: None
Bottom: None

The only fan that comes installed is the one on the rear.  The optional fans are not there.  There appears to be a place for one 120mm fan on front and places on the sides as noted above.  I've been watching the temperature sensors and this single fan in addition to the CPU and GPU fans seem to be doing the trick so far.  I hope this helps.

Questions & Answers