Thermaltake Pacific MX1 Plus CPU Water Block
This 52.2mm-tall water block delivers extreme cooling performance for your custom water loop, with a copper base and dense micro fins inside that maximize heat transfer. A mirror finished top cover gives a classy look, while allowing gorgeous, customizable RGB LED lighting to shine through when powered on. Compatible with both Intel and AMD platforms.
Unique Visual Design
The Pacific MX1 Plus CPU Water Block has a top cover made of a vacuum metalizing technique, creating a mirror finish that allows the 12 LEDs to shine under, showing our TT logo. The cylinder side cover with a height of 52.2 mm creates a depth perception for the RGB lighting to display its unique lighting effects unlike other water blocks.
The Pacific MX1 Plus CPU Water Block features a built-in temperature sensor that will pick up the temperature from the passing coolant and transmits the signal to the TT RGB Plus software. This allows users to monitor current temperature immediately whilst controlling its addressable LEDs for color editing.
Pacific MX1 Plus CPU Water Block has a copper base with a mirror finished anti-corrosive nickel plating, which is easier for users to spread out the thermal compound and provides exceptional heat transfer while keeping the water block looking as good as new.
Thermaltake’s Pacific MX1 Plus CPU Water Block has shrunk fin spacing to 0.15 mm, which is better than most design, forcing the coolant to run through a larger surface, creating the best heat dissipation result.
The Pacific MX1 Plus CPU Water block supports Intel and AMD universal brackets, allowing different CPU users to enjoy fantastic lighting effects after a quick installation.
TT RGB PLUS Ecosystem
Light up your system with almost limitless possibilities and synchronize your TT RGB PLUS compatible products (CPU/VGA water blocks, AIO CPU coolers, PSUs, LED strips, gaming keyboards, headsets, mice and mouse pads) to create a RGB ecosystem that is truly unique to you.
Cautions
Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks
1. To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
2. Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
3. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
4. Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup
1. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
2. Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
3. DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
4. Fill the reservoir to the top as it will prevent air from going into the pump
5. If necessary tilt the system slightly from side to side to bleed the air out of the loop.
6. Place some paper towels under fittings and joining points to test for leaks.
7. Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
8. Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
9. Coolant might fade over time.