RGB LED Motion Sensor Light Indoor, Bright & Dimmable, Long-Lasting

What Are Improved:

1. Brighter: Upgraded Brightness.
2. Long-Lasting Charge: Dimmable 10-100 Hours in ON-Mode, Usually Months-Lasting in Auto-Mode.
3. Cool or Warm White & 7-RGB Colors.
4. Responsive Motion Sensor with Day / Night Modes.
5. Remote Control with Timers and so on.
6. Rechargeable: Save lots of batteries

Very Handy without AA batteries. Great for indoor use, both home and travel.

GREAT for SMALL spaces. Might need more lights for large spaces.

NOTE: Please do not block the light's motion sensor, and install it facing your movement area for better sensitivity and longer detection range (max ~16 ft, 120°)!

With the AUTO-OFF-ON Light Switch, you could set it to AUTO-Mode or ON-Mode.

• AUTO-Mode: Auto turns ON when motion detected, and auto turns OFF in 20s after no motion detected.
• OFF-Mode: Turns OFF.
• ON-Mode: Stays ON. [NOTE] You could also run all functions including the Auto-Mode here with the Remote Control. Please refer to the Remote Directions.

You could set it to Day-Auto-Mode or Night-Auto-Mode with the Remote Control:

• Day-Auto-Mode: Auto turns ON whenever motion detected.
• Night-Auto-Mode: Auto turns ON ONLY when your ambient light is Dark Enough and motion detected.

Turn the Light Switch to "ON" before you use the Remote Control

Remote Functions:

1. Turn ON/OFF the light.
2. Set to or run in Day-Auto-Mode/Night-Auto-Mode.
3. Pick a White or RGB Color.
4. Set to Auto-RGB-Cycling.
5. Adjust 10-level Brightness.
6. Set a 10min/30min/1H/2H/4H Timer.

** Please Note: The Remote Control ONLY works when the Light Switch is switched to "ON"(ON-Mode), and you could run all functions here, then all the settings except the Timer remain when the Light Switch is switched to "AUTO"(AUTO-Mode).

Rechargeable & Long-lasting

• ON-Mode: 10 ~ 100+ Hours at 100% ~ 10% Brightness.
• AUTO-Mode: Usually Months-lasting. Including Day / Night Modes.

Note:

1. The Lower brightness, if applicable, the Longer time it runs.
2. Set to AUTO-Mode, if applicable, to get Longer runtime.

Easy to install:

1. Attach directly to any ironware.
2. Attach to the magnetic plate.
3. Hang via the hanging hole on the back.

NOTE: Please do not block the light's motion sensor, and install it facing your movement area for better sensitivity and longer detection range (max ~16 ft, 120°)!

Great for Kitchen, Cabinet, Closet, Pantry, Shelves, Stairs, Hallway, Washroom, and etc.