Watercool MO-RA IV 200 Front Logo aRGB (26241)

An illuminated aRGB logo board for the front of the MO-RA IV 200 radiator, held by magnets and run at +5 V through a 3-pin connector. The Watercool MO-RA IV 200 Front Logo aRGB runs from a separate controller, and the connection cable for that comes in the box.

Properties

• Compatible: MO-RA IV 200
• Operating voltage: +5 V
• Connector: 3-pin (5VDG, 5V)
• Needs: MO-RA IV Active or Passive Control

A lit MO-RA logo

The illuminated logo makes the front of the MO-RA IV look even more stylish. Behind it sits a high-quality aRGB board, and thanks to the modular design the installation is easy. Watercool says the Front Logo aRGB is supported by all common mainboard manufacturers. That means this MO-RA logo can be easily integrated into any lighting concept.

Mounting

The board is pushed in behind the logo, in the middle between the pipe bends. Only when it has reached its final position is it rotated by 90°, and magnets then keep it fixed in place. The manual shows how the cable is routed, and it is connected to the active or passive control. The tool Watercool names for the step is a Torx TX20.

What it needs

A MO-RA IV Active or Passive Control is required to use the MO-RA IV LOGO aRGB. Watercool's technical data name the MO-RA IV 200 as the compatible radiator; it is in stock as the MO-RA IV 200 - White. The MO-RA IV 200 Ambient Light aRGB (26240) lights the same radiator from underneath.

In the box

The scope of delivery has the board and its cable.

• 1x MO-RA IV Front Logo aRGB
• 1x connection cable for passive/active control