Xion XON-DRBY525MB 5.25" Driver Bay Cover Kit, Mesh, Black

Pros: Fits perfectly in my Silverstone RV01 case. Nice replacement from stock. I was shocked at how sturdy these are, I was expecting them to be rather flimsy. $10 is a great value for 2 of these.

Cons: None

Pros: nicer looking than anything I could have made. allows for better air flow.

Cons: doesnt fit with exactness, just acceptable-ness

Overall Review: even at 2pc per package this item should be priced at half of what it sells for. This is the only item I've bought from the egg that I feel I've gotten jipped on. Still, it's the one I wanted so I bought it. If you need something like these mesh bay covers, these do the job.

Pros: modified a 5.25"->3.5" hard drive adapter to hold a small CPU fan in front of the drive, right behind this bay cover - 15C drop in HD temp as reported by SMART as a result :) Fair amount of work to make it happen, but could not find anything equivalent pre-made. All the pre-made units use 1" thick fans, which pushed the HD too much inside the case - conflict with my memory cooler.

Cons: A little too small - there is gap on top and bottom of the grill.

Dust accumulates on the grill, due to the airflow - it needs to be wiped clean once a week. You can wipe from outside the case - no need to take it apart to remove the dust :)

Overall Review: I found the screw mounting a good idea - helped me with my mods - used the top screws holes on each side, and cut off the bottom; on the HD adapter I cut off the top and kept the bottom :)

Pros: Only bay covers i could find on here, reasonably priced and spiffy looking compared to my duct tape and wire mesh setup.

Cons: Did not like how they mounted in my case.

Pros: These things are great ! They look better than the plastic covers that came with the case !! Plus they double as intake vents !

Cons: None

Overall Review: They are a bit expensive considering .......

Pros: They're a nice mesh covers.

Cons: They don't fit perfectly, there is some separation above and below.

Pros: Cheap, looks good, improved airflow significantly in my mini ITX case. I see a 10C drop in hard drive temps due to allowing airflow past the drives.

Cons: I had a hard time mounting in my case, the screw holes in the cover didn't line up with the ones in my 5.25" bay.

Overall Review: It would be nice if there was a version that clipped into my front panel like the original plastic cover instead of using screws.

Pros: Opens up the top of my case so my power supply and get as much cooling as it fan can pull. Looks good, is solidly made. My CPU temp dropped 4°C when I installed these.

Cons: None