Question 1

I have 5 cameras with Ethernet connection (Samsung unit-died), would like to avoid rewire, they went from Samsung base to my DVR with bnc connection.  I want to power up the 6 pin Ethernet cameras then send signal to the DVR via bnc connection. Will this work & how?

Accepted Answer

You don't provide sufficient information about what you're trying to do so it is hard to provide an answer. However, 1st, Ethernet is 8-pin (4 pairs of wires), not 6. Second, you said your cameras have an Ethernet connection, but were connected by BNC to the DVR (what's a "Samsung base" anyway?). Sounds like you want to continue using the existing BNC cabling to support the cameras, yet also use PoE to power them via their Ethernet port?  I seriously doubt any camera is going to use both interfaces at the same time, but even if they did, you can't supply power to the Ethernet port without Ethernet cable run between the switch and the cameras.

Question 2

Is this PoE switch compatible with Cisco's AP: AIR-LAP1252AG-A-K9?

Accepted Answer

I haven't installed it yet, but the specs are great.  The IP address preset by Trendnet is outside of the range I normally use, so that will be need to be addressed when I do the install.  There are instructions on how to do it.  I'm not an IT geek, but think it will be fine.

Brand	TRENDnet
Model	TPE-1020WS

Format	Rackmount
Standards	IEEE 802.3/3u/3ab, IEEE 802.3af/at
Network Management Type	Smart

Primary Ports	10 x RJ45, 2 x shared SFP
Primary Port Speed	10/100/1000Mbps

MAC Address Table	16K
VLAN Support	Multiple management VLAN assignment Asymmetric VLAN 802.1Q Tagged VLAN Dynamic GVRP Up to 256 VLAN groups, ID Range 1-4094 Private VLAN (Protected Ports) Voice VLAN (10 user defined OUIs)
Jumbo Frames	10 Kbytes
Buffer Memory	8 Mbits

Protocols	TCP/IP
PoE	Yes
SNMP	Yes
QoS	Yes
LACP	Yes
Port Mirroring	Yes

TRENDnet 10-Port Gigabit Web Smart PoE+ Switch, 8 x PoE+ Gigabit Ports, 2 x Gigabit Ethernet Ports, 2 x Shared SFP Slots, 75W Total Power Budget, Rack Mountable, Black, TPE-1020WS

Learn more about the TRENDnet TPE-1020WS

Customer Reviews of the TRENDnet TPE-1020WS

Warranty & Returns

Warranty, Returns, And Additional Information

Warranty

Return Policies

Manufacturer Contact Info

Dimensions	330 x 183 x 44.45 mm (13 x 7.2 x 1.75 in.) Rack mountable 1U height
Weight	1.9 kg (4.1 lbs.)

Temperature	0°C to 40°C (32°F to 104°F)
Humidity	90% Maximum, Non-condensing

Item#: N82E16833156460