- ABS/PLA Filament
- 1.75 mm Filament Diameter
- Up to 5.9 x 7.8 x 7.8 inches Build Volume
- 100 - 400 microns Layer Thickness
- USB 2.0
So much better than I ever expected 07/02/2016
This review is from: XYZprinting da Vinci 2.0 Duo FFF (Fused Filament Fabrication) ABS/PLA Dual Nozzle 3D Printer
Pros:
For the price I paid I was expecting a printer that would "do the job", but what I got was a 3D printer that has surprised me. There are complaints and star reduction concerning the fact that this printer uses cartridge based proprietary filament. However, this is never hidden and most purchased the printer knowing this limitation, yet lower the review because of it. Filament is 600 g instead of 1K, but is usually cheaper. Again never hidden. Benefit of the cart filament is...more consistency, internal storage, tested with your model of printer, easy install, I believe they also have moisture packs in them (saw on video, but have not confirmed).
Software is fine for beginning software, and has much of what someone needs to get started. It actually provides very good prints. You don't get a lot of options, but since this printer seems to be tweeted to work well without much need for this. I personally purchased Simplify3D because I do like the extra control and features though.
Also some complain about customer service, and I assume is probably as bad as stated, but I can't speak to this as I have not had to use them yet, and hope I never do. However, some are complaining that if there is an item covered under warranty they expect XYZ to pay for shipping to them. I admit that would be nice, but MOST companies are the exact same and require you, the customer, to pay for shipping to and the company pays for shipping back. Also, this is spelled out in their warranty information, and is never hidden from the consumer.
With that said, I have about 100 hours on it, and so far enjoying it. It provides great prints, at a great price. If I ever have to use customer service I might change my tune, but for now it is one of my all time favorite purchases. Make sure you read between the lines on the negative review. Some are justified, but others giving low review for things they should have known before the purchase with minimal research.
Cons:
None that I didn't already know before I bought the printer, so hard to put as a con. Definitely won't remove any eggs for, but will list a few things.
1. Proprietary filament - Knew before buying
2. Not opensource - Knew before buying, but Simplify3D works with the printer, and the program is great.
Overall Review:
I was not sure what to expect when I bought this printer, but got more than what I ever thought I would. I have since looked at many other 3D printers, including one that is about $2500, and still no buyers remorse. This printer is on my list of all time favorite purchases, and New Egg got it to me very quickly.
2 people found this review helpful. Did you? Yes / No