BEST SELLERS

In Computer Cases

This case is one I very much enjoyed the look aesthetically. It was very easy to build in, and the fact that it supports up to 2 360mm radiators, from what I can tell, means that you can support very advanced cooling if you're running a system that needs it! More than ample space needed for larger GPUs, though be careful of gpu sag and make sure to buy a mount while keeping the constraints of your case and your graphics card in mind. For instance, if I were to add fans to the case's bottom, I would want to change the gpu mount. The dust filters on this pc are fantastic! One for the psu basement, one on the back panel for those three fans, and one more filter on the top meaning dust will have a bit of trouble building up in this case, though in general make out you dust out your pcs every 6-12 months, (to be honest with this case I'd bet you could easily get away with several more months) especialy your aio coolers as dust can get stuck and built up behind the fans (speaking from personal experience). Motherboard standoffs were pre-installed for ATX, I'd recommend using an ATX mobo for this case obviously as any smaller would look dwarfed inside of the large case, this thing is pretty big! My last corsair ATX case (Sitting right behind this pc) is dwarfed by comparison! If you also like the looks of this case I fully recommend it! My one problem is very minor to the point it wasn't enough to bring my rating down, if I could rate between 4.5-4.9 I would.

Easy to set up. Very customizable. Quiet. Tooless entry to case. Thumb screws for everything internal.

It is a fine case Has good air flow

Mirrored fan designs look great and the double glass fits the look I went for.

Fully customizable Great for my storage needs Not too heavy Overall great fit and finish

Very easy to work in easy cable management Clean look Spacious

- The quality of the case is nice, it feels good to build in and handle around. - The 4 preinstalled ARGB fans are a really nice feature, making this a top 3 budget PC case.

- Good Size - Easy to build in - Looks nice - Fits 240 mm AIO

Very big case, looks way larger than in pictures nice airflow and it comes with the correct screws for easy installation

At this price point this is a gem. I’m surprised there aren’t any reviews online for this case.

Powder coated inside and out No standoffs needed--built in to the motherboard tray.

This case has close tolerances and has been the easiest case to build that I have experienced. It is the best looking case I have owned.

This is one of the more compact cases in the true mid-tower ATX segment. A little less than 17" deep is going to be hard to beat in a case that can accommodate GPUs over 16". The case includes a F360 RGB fan setup in the front where the non-RGB just has a single fan. So, upgrading to the RGB case for $25 gets you an upgrade from a basic $15 fan to a frame that retails for $70-80. It's worth it even if you don't use the RGB features and installation is a bit easier and cleaner, since the block is already wired to a single power and RGB connector.

Captive screws on the side panels Filters on the top and bottom Fine metal mesh for front panel Plenty of room for water cooling and radiators

Sturdy build, fantastic cooling solutions, plenty of room to work in, well, I just can't say enough about this case! Lian Li, you NAILED it!

Looks, size, customizability, l.

Item came in very quick no damages 10/10 would buy again