whats the maximum cpu cooler size?

This case is big anough to hadle most Air coolers out there, i had installed dual towers and dual fans on it I think it is a matter of your motherboard and how much will the tower cover and fit

are other 200mm fans supported in this case?

I believe you can take the preinstalled fans out and install different ones don't see why not

Is there an off setting for the RGB?

Yes. If you long press the led control botton you can turn them off. You can also run the fans to an rgb header and turn them off like that.

Do i need somthing on my motherboard to control the rgb? or can i just plug them in and install software?

If you want to sync up your RAM or other RGB items then yes you will need an RGB header on the motherboard. But the 3 RGB fans included are pre plugged into a header and are controlled with a switch that is on the front top part of the case.

How are the temperatures inside the case?

the front fans are defiantly restricted but it still has good air flow, without the glass on the front my gpu is at 69c but with it on it gets to 71c so there is difference.

does this case support AIO? in the top and if not where.

I think you would be fine with a single fan (120 or 140) Rad up top or at the back.

Does anyone who owns this case know if the fan speed is adjustable? I have it, and when I hold down the LED button, the LEDs flash once or twice, alternating each time I hold the button. I assumed this was adjusting the fan speed, but I don't hear or see any fan speed difference, and the temps don't change.

I contacted DIYPC and the fan speed is NOT adjustable. Despite the description on Newegg saying the fans have PWM ability, they do not and are a constant speed.

DIYPC DIY-Model C-RGB Black Dual USB3.0 Steel/ Tempered Glass ATX Mid Tower Gaming Computer Case w/ 3xTempered Glass Panel and Aura Sync RGB LED Fans

DIYPC DIY-Model C-RGB Black Dual USB3.0 Steel/ Tempered Glass ATX Mid Tower Gaming Computer Case w/ 3xTempered Glass Panel and Aura Sync RGB LED Fans ( 2 x 200mm Fans x Front and 1 x 120mm x Rear Pre-Installed)

3 x Tempered Glass Panels : Front and Both Sides
Pre-installed 2 x 200mm RGB LED Fan x Front and 1 x 120mm RGB LED Fan x Rear (7 different color in 3 modes control- circularly flashing, breathing and stable)
2 ways to control RGB Lighting: Either by Manual RGB LED Button on Top Panel; or if your Motherboard has RGB connector, this case has Aura adapter(5V) ready to SYNC w/your motherboard to control RGB lighting
Water cooling ready - Front can fit up to 240mm water cooling radiator
2 x USB 2.0 / 2 x USB 3.0 / HD Audio In/Out Front Ports
Advanced cable management design - 29mm
Magnetic dust filter at top - easy clean

🔥Don't forget your OS, we have Windows 11 OEM, Download and USB versions available

DIYPC DIY-Model C-RGB

Beyond a computer case, this mid-tower chassis is also a showpiece with three 4 mm tempered glass panels (front and both sides) and three pre-installed rainbow RGB fans. These fans can be manually controlled via the top button, or be tuned via motherboard RGB lighting solutions like ASUS Aura Sync, Gigabyte RGB Fusion, MSI Mystic Light Sync and ASRock RGB LED.

The C-RGB is more than a piece of eye-candy. It offers ample space to house high-end components, features a bottom power supply shroud for clean look and independent PSU cooling, and has wide clearance behind motherboard tray for routing and hiding cables, so you can build your powerhouse clutter-free.

Two cases, one faces forward with no lighting and the other to side showing rainbow-colored fans

Full Clear Tempered-Glass At Front

Two cases, one front-facing to the left side and the other with its panel open facing away to the right side

Full Clear Tempered-Glass On Both Side Panels

Case with 3 red-lit fans facing to the right with text that reads 4MM (Thickness)

Total of Three 4mm-Thick Tempered-Glass Panels
(Front and Sides)

Closeup of the case's top panel showing ports

If your motherboard has an RGB connector, this case comes with an Aura adapter that's ready to sync with compatible motherboards for RGB-lighting control.

How to Use the AURA Adapter

Step I: Ensure the motherboard has a 5V addressable RGB header (Rainbow RGB).

Step II Find the AURA adapter on the RGB controller.

Closeup shot of the 4-pin cable and the 4-pin male connectors on a motherboard

Step III: Connect the AURA adapter (5V addressable 3-pin connector) from the case to the addressable RGB header on the motherboard.

DIYPC case with logos of compatible RGB software and where the CPU cooler and graphics card can be inserted

Side shot of the case with its panel removed showing where cables can be routed

Advanced Cable Management (29mm)

The case with its panel removed showing where fans can be installed and how they can affect airflow

Type	ATX Mid Tower
Color	Black
Case Material	Steel / Tempered Glass
With Power Supply	No
Power Supply Mounted	Bottom
Motherboard Compatibility	Micro ATX / ATX / Mini-ITX
Side Panel Window	Yes
LED	RGB

Internal 3.5" Drive Bays	2
Internal 2.5" Drive Bays	3 (SSD)
Expansion Slots	8

Fan Options	Front: 2 x 200mm RGB LED fan (Pre-Installed) Rear: 1 x 120mm RGB LED fan (Pre-Installed) Top: 2 x 120/140mm fan (Optional) Top of Power Supply Cage: 2 x 120mm fan (Optional)
Radiator Options	Front - Up to 240mm

Max GPU Length	383 mm
Max CPU Cooler Height	162 mm
Max PSU Length	190 mm
Dimensions (H x W x D)	19.28" x 8.60" x 18.00"
Weight	13.00 lbs.

DIYPC DIY-Model C-RGB Black Dual USB3.0 Steel/ Tempered Glass ATX Mid Tower Gaming Computer Case w/ 3xTempered Glass Panel and Aura Sync RGB LED Fans ( 2 x 200mm Fans x Front and 1 x 120mm x Rear Pre-Installed)

Full Clear Tempered-Glass At Front

Full Clear Tempered-Glass On Both Side Panels

Total of Three 4mm-Thick Tempered-Glass Panels
(Front and Sides)

Advanced Cable Management (29mm)

Magnetic Dust Filter on Top

Learn more about the DIYPC DIY-Model C-RGB

Customer Reviews of the DIYPC DIY-Model C-RGB

Warranty & Returns

Warranty, Returns, And Additional Information

Warranty

Return Policies

Manufacturer Contact Info

Item#: N82E16811353158

DIYPC DIY-Model C-RGB Black Dual USB3.0 Steel/ Tempered Glass ATX Mid Tower Gaming Computer Case w/ 3xTempered Glass Panel and Aura Sync RGB LED Fans ( 2 x 200mm Fans x Front and 1 x 120mm x Rear Pre-Installed)

Full Clear Tempered-Glass At Front

Full Clear Tempered-Glass On Both Side Panels

Total of Three 4mm-Thick Tempered-Glass Panels (Front and Sides)

Advanced Cable Management (29mm)

Magnetic Dust Filter on Top

Learn more about the DIYPC DIY-Model C-RGB

Customer Reviews of the DIYPC DIY-Model C-RGB

Warranty & Returns

Warranty, Returns, And Additional Information

Warranty

Return Policies

Manufacturer Contact Info

Total of Three 4mm-Thick Tempered-Glass Panels
(Front and Sides)