MAIWO K25272 Business Portable MINI RAID Enclosure
With USB3.0, the maximum transmission speed can reach 5Gbps.Supports simultaneous reading and writing of two 6TB 2.5-inch SATA hard drives, with a maximum capacity expansion of 12TB.Tool-free installation, support hot swap, plug and play.Built-in sponge cushion, stable and shockproof.10 minutes smart sleep,LED blue indicator light always on in standby, flashing when reading and writing.
With USB3.0, the maximum transmission speed can reach 5Gbps.
Supports simultaneous reading and writing of two 6TB 2.5-inch SATA hard drives, with a maximum capacity expansion of 12TB.
Tool-free installation, support hot swap, plug and play.Built-in sponge cushion, stable and shockproof.
comes with the USB 3.0 connection enhanced with the UASP protocol, delivering up to 70% faster performance than conventional USB 3.0 connection.
- RAID 0: Merge all HDD's capacity in the HDD enclosure and upgrade it's performance (reading and writting speed).
- RAID 1: Two HDD's in the HDD enclosure can backup each other, cannot upgrade it's performance(reading and writing speed), and it can support self restoration function (RAID 0 modes cannot support this function), which makes files can be restored when mistaks and faults occur.
- LARGE: Merge all HDD's capacity in the HDD enclosure to make it easy to manage but can not upgrade it's performance.
- Normal: means normal state, all HDDs in the HDD enclosure work independently without forming any RAID modes.
MAIWO K25272 hard drive enclosure use steps
1.Remove the middle frame of the hard drive enclosure, install 2.5-inch hard disks at 45 degrees to the HDD1/HDD2 separately, fix the hard disks with screws, Put the installed hard disk middle frame back into the hard drive enclosure and fix the middle frame with screws.
2.After setting the function mode, connect the K25272 dual-disc hard drive enclosure data cable to the computer end interface, connect the power supply at the same time, press and hold the RESET button, turn on the power switch, wait 5-8 seconds, the RAID indicator lights up and let go, at this time USB driver will be installed automatically in the lower right corner of the desktop
3.Note: If you are connecting to a new hard disk, right click on the computer desktop "Computer" - "Management" - "Disk Management" - find the corresponding disk first "Initialize Disk",then "New Simple Volume". See the manual for details on RAID usage.

















