Alpine SBV-10-WRA Pre-Loaded 10-Inch Subwoofer for 2007-2018 Jeep Wrangler JKU With Panel Tool Kit

OVERVIEW
10-inch subwoofer pre-loaded into a sealed, custom-fit enclosure
Designed to be pressure fit under the front passengers seat rails, no mounting hardware is required
Trail Ready - Rated at IP66 for protection against total dust ingress and water from any direction
OEM-grade weather resistant Molex 2-pin connector with pigtail wire harness
Nominal Impedance: 2 ohm
Frequency Response: 45-200Hz
The 300W RMS/900W max power rating is a match for the KTA-30MW Mono Tough Power Pack Amplifiers
SMART USE OF SPACE WITH EASY INSTALLATION
When you have a Wrangler, you dont have extra space to spare. Alpine engineered the SBV-10-WRA to conveniently fit under the front passengers seat making efficient use of space. The SBV-10-WRA is a custom-shaped enclosure that fits snugly under the seat frame, so no mounting hardware is required. (NOTE: designed for fitment in Jeeps with the factory carpet. Fitment is not guaranteed with aftermarket or removed carpet)

WRANGLER-READY BASS
Enjoy impactful bass, with your Wranglers top on or off. The SBV-10-WRA loads the lower frequency sound into the passengers foot well to deliver quality sound and maximized bass extension at all times, so your music continues even when the asphalt ends.

WEATHER RESISTANT
Driving with the top off is part of the fun of owning a Wrangler, but you sometimes get caught off-guard with the top down and inclement weather. The SBV-10-WRA is weather resistant and rated IP66, so its protected from total dust ingress and water from any direction.