Welcome to Uowlbear.
We are a professional factory in producing cell phone batteries.
We always insist on provide the high quality batteries. High quality IC conversion rate improves the utilization of the battery capacity.
Uowlbear cell phone battery tested strictly by professional machine for 3 times before shipping. You can buy the Uowlbear replacement battery with confidence. You will get a high capacity battery from us. Uowlbear battery will brings your phone a new life!
We also provide installation video. You can watch it before replacing the battery.
Note: Other sellers are not authorized by us to sell Uowlbear batteries, and we are only responsible for Uowlbear batteries sold in our store.
Specifications:
Compatible Models: A1662, A1723, A1724
Battery Capacity: 2560mAh
Voltage: 3.82V
What You Get:
1 Battery for iP SE
1 Manual
1 Suction Cup
1 SIM Eject Tool
1 Plastic Spudgers
2 Opening Tools
2 Set Adhesive Strips
3 Screwdriver (Pentalobe, Slotted, Phillips Size)
Replacement Battery for iPhone SE.
Uowlbear IPSE replacement battery is brand new, 0 Cycle and over 900 charging cycles.
The circuit protection system ensures your battery is protected against over-loading, over-heating, over-charging,and short-circuit, More reliable and safer!
Uowlbear Battery is 57% higher than original.
Reduce the times of charging the battery per day.
More battery capacity, more time to use your phone.
Uowlbear battery is built in high quality IC chip.
Dual IC design ensures that your battery won't fail under any circumstances and give your cell phone super protection.
Note:
- We strongly recommend you to watch the installation video before you replace the battery. After watching the video, you will find that it is not very difficult to replace the battery.
- Before disassemble your phone, discharge the battery below 20%. A charged lithium-ion battery can catch fire or explode if accidentally punctured.
- If you are unable to turn your phone on after installed, please reinstall the ribbon cable, check its connector and clip it hard. Next, charge your phone for 20 minutes or longer. Then try to turn on your phone once again.
- If your phone keeps rebooting and blinking apple logo or can't hold a charge. Maybe the ribbon cable does not connect well. Please reinstall the ribbon cable, check its connector and clip it hard.