1500W Fog Machine with Lights 24 RGB LED Stage Smoke Machine Vertical Halloween Smoke Machine DMX/Wireless/Manual Control 2.5 Liters with 20000 CFM for Wedding Christmas Party Outdoor Indoor

Fog Machine with Lights Instructions for
Use:
1. Ensure the power cord is connected to the switch.
2. Locate and turn on the red switch on the side.
3. Initial heating requires approximately 3-5 minutes. After preheating, the red indicator light will turn on. Press the button on the receiver or the remote control to generate mist! Subsequent heating cycles take about 30-40 seconds.
4.
Note: Before operation, confirm there is adequate mist liquid in the mist tank. After use, allow the machine to cool down before further operation. Overheating will automatically activate the protection function, preventing normal mist output.
Smoke Machine Safe Use: Tank
Capacity: 2.5 liters
1. Before use, make sure the tank cap is fully tightened to avoid leakage.
2.
Do not overfill: Leave ample space in the tank. Overfilling can cause overflow and internal leakage.
1500W Fog Machine Precautions: Keep
the machine level: Always place the machine on a stable, level surface. Avoid tilting beyond 45 degrees, as this could lead to liquid spillage. Use high-quality water-based smoke oil. Using inferior or unsuitable liquids will clog the system, corrode seals, and cause irreversible damage to internal components, resulting in inability to use the smoke machine normally.
Common Problems and Troubleshooting:
1.
No smoke/low smoke volume: (1) Insufficient preheating (2) Insufficient smoke liquid or blocked oil circuit (3) Cracks in the fluid pipeline or loose connection (4) Pump failure.
2. Smoke has an odor or color: (1) Use of incorrect or inferior smoke liquid (2) Carbon deposits on the heating block, requiring professional cleaning or replacement.
3.
Unable to preheat: (1) Power supply problem (2) Damaged heating block (common after dry burning).
4.
Machine leakage: (1) Oil can not tightened (2) Broken fluid pipeline or loose joint.
Smoke Machine Maintenance Requirements:
1. Empty the pipeline. After the performance or event, while the machine is still hot, disconnect the smoke liquid pipeline and place the pump pipe into an empty container.
2. Activate the machine multiple times until no smoke is discharged from the nozzle and only air is released from the pipeline. This step is to clear any residual fumes and liquids from the pump and pipes to prevent them from solidifying and clogging upon cooling.
3. After evacuation, switch off the machine power.
4.
Cooling and storage: Let the machine cool naturally in a safe environment for at least 30-60 minutes. Do not pack it immediately while it is still hot.
Precautions: The initial heating time must be strictly controlled within 3-5 minutes. Heating for too long or too short a time may result in the product failing to emit smoke