Fastronix 500A Ultimate Duty Battery Disconnect Switch with Mounting Bracket and Hardware

Heavy Duty Handle can be Held in Place with Roll Pin (Included) or #10 Machine Screw (Not Included)
Use Mounting Bracket as a Template to Mount the Switch in any Panel up to 1/2" Thick
Sealed Internals to IP66 / IEC529 Standards
Installation Instructions
Install the Mounting Bracket
Use the 3 larger holes and included hardware to mount the bracket in a convenient location.
Install the Switch
Install the switch into the mounting bracket through the large hole and align the index pin with one of the 4 small index holes.
Install the Face Plate
Install the face plate and align the notch in the face plate with the index pin on the switch.
Install the waved washer, followed by the nut and tighten.
Install the Handle
Slide the handle into place on the operation shaft. Align the hole in the handle with the hole in the shaft.
Push the roll pin through the hole in the handle. The roll pin will need to be installed with a hammer or clamp.
(Alternate installation: Obtain a #10 machine screw with a lock nut and install that through the hole in the handle)
Features
Labeled Face Plate
Shows On and Off Position as well as operational direction.
M10 Terminals with Divider
M10 Studs compatible with 3/8" Wire Ends.
Terminal Continuous Duty Rating:
500A@12VDC
300A@24VDC
Heavy Duty Handle
Use included roll pin to attach the handle to the body of the battery disconnect switch.
If desired, the switch can be operated without the roll pin installed. Slide the handle on the switch, turn to desired position, and remove the handle.
Alternatively, a #10 machine screw can be used with a lock nut to secure the handle for easier removal. (Not Included)
96 Mounting Configurations!
Universal mounting allows the user to customize their installation to fit specific needs.
Technical

Specifications

Maximum Intermittent Current 2000 Amps at 12 Volts (Less than 5 Seconds)
Maximum Operating Current 500A@12VDC / 300A@24VDC
Maximum Operating Voltage 32VDC
Wire Stud Size M10 (Compatible with 3/8" Wire Lugs)