RP2350-PiZero Development Board, Based On RP2350 Dual-Core & Dual-Architecture Chip, 16MB Flash Memory, DVI Interface, TF Card Slot, PIO-USB Port, 40PIN GPIO, Compatible with Raspberry Pi Hats, LCD

RP2350-PiZero is a high-performance and cost-effective microcontroller board, onboard DVI interface, TF card slot and PIO-USB port, 40PIN GPIO header (Compatible with Raspberry Pi HATs), with reserved solder pads for PSRAM chip expansion, easy to develop and integrate into products.
Based on RP2350B microcontroller chip, adopts unique dual-core and dual-architecture design: dual ARM Cortex-M33 or dual Hazard3 RISC-V processors support, flexible clock running up to 150 MHz 520KB of SRAM, and 16MB of onboard Flash memory, with reserved solder pads for PSRAM chip expansion.
Onboard DVI interface can drive most HDMI screens (DVI compatibility required). Supports using as a USB host or device via onboard PIO-USB port. Onboard TF card slot for reading and writing TF card. Type-C connector for easier use.
Onboard Lithium battry recharge/discharge header, suitable for mobile scenarios. USB 1.1 with device and host support. Low-power sleep and dormant modes. Drag-and-drop programming using mass storage over USB.
Adapting 5 x multi-function GPIO pins. 2 × SPI, 2 × I2C, 2 × UART, 2 × 12-bit ADC, 16 × controllable PWM channels. Accurate clock and timer on-chip. Temperature sensor. Accelerated floating-point libraries on-chip. 12 × Programmable I/O (PIO) state machines for custom peripheral support.