Record Player,3 Speed Turntable Vinyl Record Player with Bluetooth Speaker, MP3 Player Portable with FM Stereo Radio, Vinyl to MP3 Recording Phonograph Player, Brown

3 Speed Vinyl Record Player for 3 Size
-33RPM for 12 inch vinyl
-45RPM for 7 inch vinyl
-78RPM for 10 inch vinyl
-Included 45RPM adapter on plate, use it to fixed large bore diameter vinyl records, such as 7 inch vinyl.
Auto stop Switch
-ON: The vinyl record will be stop automatically when finished, the stylus won't scratch the vinyl record.
FM Radio Player:
-Press the FUNC button on the record player, it will shows FM on the LED display.
-Press the skip down or skip up button to tune your desired station.
-Adjust volume knob for desired volume level.
-The record player can store up to total of 20 radio stations in the memory.
-The receiver has a built-in FM wire antenna hanging at the rear cabinet. This wire should be totally unraveled and extended for best reception.
Bluetooth:
-The vinyl record player support the smartphone, tablet or other bluetooth enabled device to turntable via bluetooth pairing.
-Maximum streaming distance:10 cm.
Note:
-Refer to the manual of your cell phone, tablet PC, computer or other Bluetooth enabled devices for Bluetooth operation since it may vary from model to model.
-If your Bluetooth enabled device does not support A2DP profile, it will not play the music through the speaker, even if paired (linked).
-The music playback will automatically be paused when you have an incoming call. When the call is ended, the unit will start playing again.
-The Bluetooth operation will be interrupted if Aux-in jack is being connected.
Vinyl to MP3 Encoding:
- Before the vinyl started playing, insert the USB flash drive into the turntables port and press the REC button, the vinyl songs will be stored in the USB. Even if you dont have the vinyl, you could play music that stored in USB on record player directly.
Track separation by remote handset when vinyl to MP3 encoding:
-You can divide the recording music from phono or tape to USB track by trace during encoding. Every time when press the TS button once at remote handset during encoding from phono/Aux to USB, the system will generate a new track and continuous the recording.
-This has the advantage of being able to skip the song and choose the next one.
-If the TS button is not pressed when vinyl to MP3 encoding, there is no option to skip when playing, and you can only listen to the songs in order.
Removing of USB
-To remove the USB turn off the power or switch the function mode to either tuner or phono first. Then, un-plug the USB by pulling out directly.
Aux-in connection
-Connect the unit to any auxiliary device, such as MP3 player or iPad by connecting the aux in jack with one end of 3.5mm stereo cable (not included) and the other end connect to the auxiliary device to perform the music.