0.96inch OLED Module 128 × 64 Pixels OLED Display I2C SPI Screen with SSD1315 Driver Chip Yellow Blue Two-Color Display Compatible with Raspberry Pi/Arduino/STM32

0.96 inch OLED Display Module. Embedded SSD1315 Driver Chip, SPI / I2C Communication. Comes with examples for Raspberry Pi, Arduino, STM32, etc.

Specifications

Operating voltage: 3.3V /5V (IO high-level voltage is as same as the power supply. )
Communication interface: 4-wire SPI / I2C
Screen type: OLED
Control chip: SSD1315
Resolution: 128 × 64
Pixels Outline dimensions: 26.0 mm × 26.0 mm
Display size: 21.74 mm × 11.18 mm
Display colors: Blue/White/Blue and Yellow (1/4 yellow on the top)
Operating temperature: -20°C ~ 70°C
Storage temperature: -30°C ~ 80°C
Viewing angle: > 160° Control Interface RES---Reset, low active DC---Data/Command selection (high for data, low for command) CS---Chip selection, low active CLK---Clock input DIN---Data input GND---Ground VCC---Power ( 3.3V / 5V input) Package Content 0.96 inch OLED Module x1 Jumper cable female-female 7PIN x1 FAQ How many volts can the OLED module be used in a system? The OLED module is used in a 3.3V system by default, but after our 24+ hour aging test, we found that it works fine in a 5V system. How many hours does the OLED module last? Under normal operating conditions, there are typically 50, 000 hours. OLED module connected to the power supply why does not light? OLED is no backlight, the display belongs to the self-luminous way. Only connected to VCC and GND, OLED will not light up. You must use the program control to highlight the OLED. What do I need to be aware of when using this OLED module?
1. Be careful not to reverse the power connection.
2. Can not display the same screen for a long time, otherwise, it will produce residual images and lead to OLED damage. Note Development Resources is provided, please contact us if you have any problem.