Mainboard 32Bit 3D Printer Mainboard with 12864 LCD Display

Pacakge Included:

main control board*1

USB data cable*1

12864 LCD display*1

Adapter board*1

Gray cable *2

Specifications:

Input voltage (recommended): 12-24V

Input voltage (limit): 6-35V

Stepping driver: 6 (support SPI socket StepStick)

MOSFET output: 6

Maximum bed current: 20A

Maximum heater current: 5A

Number of thermistor connections: 5

Limit switch: 6

Firmware: Marlin bufix-2.0

Description:

RUMBA32 is a brand new control board from Aus3D! RUMBA32 relies on Marlin 2.0's 32-bit support, which is rapidly evolving, so documentation and configuration settings may be subject to change. Please make sure you are comfortable following the instructions in our getting started guide before purchasing RUMBA32.

--- There is a small fault in the current batch of boards that means the SPI-mode for TMC stepper drivers will not work correctly out of the box. This requires a small mod with a soldering iron for each socket being used with an SPI -mode stepper driver. We can apply this mod on purchase if you plan to use SPI drivers. If you have purchased a board previously, we can provide instructions on the mod or can organise a return to have the modification made. Please see our mos instructions(pdf)or contact us for assistance. ---