3D Solex UM2 Conversion 1.75mm Nano - Dual

Key Features: Convert your Ultimaker 2 and 2+ to take 1.75 mm filament Can replace currently block or work in parallel with current block Additionally parts may be required depending on desired setup Finally you can convert your UM2 / UM2+ to go with 1.75 mm filament! You have the choice to install it in the 2nd block position (UM2), or just replace your existing block. If you have a UM2+, you need a new fan shroud with 2 holes. If you put it in the second position, you can have both setups in parallel. With this setup you will need to add a Heater and PT100 temp sensor. We recommend the 35W heater and PT100 by 3D Solex (sold separately). You can have both the old and new block installed at the same time. Item Specifics 1 - Dual Conversion kit
Fits: Ultimaker 2 & 2+