Funssor 1pcs PT100 Temperature Sensor Up to 500 Degree Molex Connector for Ultimaker 2 V6 Chimera Lite6 Hotend 3D Printer

Item Type:Temperature Resistance
Model Number:pt100a
Condition:
MPN:PT100A
Size:3x15mm
cable length:250mm

Name
:
PT100A (better than B)
Metal head Size:
3(OD) x 15(L)mm
Cable length:
250mm
The range of Temperature:
0~500 Degree
Chip: German Chip,
PT100\'s are high temperature, high accuracy temperature sensors that you can now use on your E3D V6 HotEnd instead of a thermistor or thermocouple. PT100\'s are able to measure higher temperatures than thermistors - up to 500°C, and are more accurate then both thermistors and thermocouples in general. Our PT100 sensors are also very easy to handle, being of a metal cartridge type construction that is secured with a set screw, no more fiberglass sleeving or clamping washer.
The PT100 sensor will not fit in the standard E3D Hotends, but can be used with E3D V6, Chimera, Lite6, and Kraken by using the PT100 Heater Block available in the spares and extras section.
The Ultimaker 2 uses PT100 sensors by default, and this sensor allows you to connect your E3D Hotend and Ultimaker electronics with no alteration to the electronics or firmware of the Ultimaker 2.