AT 1 to 3 4-pins Molex TX4 CPU 4 Pin PWM Net Jacket Sleeved Power Fan-out Adapter Cable Case Cooling Fan Splitter Hub

Type:Power Cable
Model Number:PWM case fan power cable
Products Status:STOCK
Package:No
NO:XZT000753
Conductor::26AWG Tinned Copper
Color::Black Sleeved
Certification::UL,RoHS
Type::PWM case fan power cable
Connector::4-pin TX4 PWM

AT  1 to 3 4-pins Molex TX4 CPU 4 Pin PWM Net Jacket Sleeved Power Fan-out Adapter Cable Case Cooling Fan Splitter Hub
Features
This TX4 4-pin multi-fan splitter cable connects to your motherboard and controls three PWM fans.
Since only one RPM signal can be read by one motherboard connector, only one 4 TIPS CONNECTOR of the fan splitter cable carries an RPM signal; thus the motherboard will only read the RPM signal of the PWM device that is connected to full 4-pin connector.
The other two male connectors are missing the pins of tachometric signal,ensure your fan speed monitor won't bounce all over the place from getting three sense signals.Guarantee motherboard getting an accurate RPM signal.
Only one of the three fans sends its tach signal (the one with full 4-pin connector) reports its RPM, but the others will still follow the PWM signal.
Compatible with 4pin PMW fan connector and 3pin fan connector  (Due 3pins no PWM controller, 3pin fans would run in full speed.)
Sleeved in a black is enhanced cable management,enclosure to provide a sleeker look that seamlessly integrates into the case's interior
Specifications
Length : about 30cm
Color :black sleeved cable
Wire Gauge: 26AWG Tinned Copper - UL1007 Wire
Cable Length: 6inch each
Connector A: 1 - TX4 4-pin Female
Connector B: 1- TX4 4-pin Male
                         2 - TX4 4-pin Male (3 wires only,missing the pin of tach)
Voltage:12VDC
Note:
Only the fan on 4-pins connector is used for monitoring.
All connected fans are following the same PWM signa, speed control is the same for all fans when use fan controller software like AI stuite/Xspert FAN and EASY TUNE,etc
PWM capable connectors must necessarily be 4-pin, but not all 4-pin motherboard connectors implement or enable the PWM signal modulation by default. Please carefully consult your motherboard documentation in this respect.
This is only a fan splitter cable,NOT fan speed controller,
Only 4pin PWM fans speed can be adjusted by fan controller software,
3pin fan would run in full speed,can not be adjusted when connect.