ThinRip Guide, Thin Rip Jig for Quickly Cutting Safe Accurate + Repeatable Narrow Strips, Inch & Metric Scales, Table Saw Accessory, USA Made - TRG

Achieve Perfectly Consistent Thin Strips Every Time - This jig serves as an accurate stop positioned ahead of the saw blade in your table saw's miter slot. Instead of adjusting your fence for each cut, simply slide your workpiece closer to the blade for flawlessly identical thin strips. Laser-engraved inch and metric scales offer highly precise repeatability. Safer, More Controlled Cutting - Cutting thin strips on the offcut side removes pinch points, kickback risks, and uneven cuts caused by blade deflection. The dual bearing system ensures smooth, low-friction material guidance, minimizing resistance while maintaining each strip's uniformity. No need to constantly measure or readjust, just secure your setting once and begin cutting. Simple Setup & Broad Compatibility - This guide is compatible with any table saw featuring a 3/8" x 3/4" miter slot with a T-slot, ranging from portable jobsite saws to industrial cabinet saws. Achieve strip thicknesses as fine as 1/32" (or even thinner if the material permits) and up to 1-1/4" wide. Straightforward calibration: bring the bearings to the saw tooth, adjust the scale once, and you're set for easy repeat cuts. How to Use - Insert the guide into the miter slot a few inches before the blade and secure it in place. Set your desired strip thickness using the laser-engraved scale and lock the setting. Place your workpiece against the bearings and lock your fence so your material just contacts the guide. Make the cut and repeat as needed. Each strip will match the first precisely. Manufactured in the USA - This guide is produced in Strongsville, Ohio from solid aluminum for strength and stability