Telink TLSRGSOCBK56B Burning Board Programmer, Firmware Download & Debug Tool for TLSR82xx BLE SoC (TLSR8258/825x), with USB Cable

Telink TLSRGSOCBK56B Burning Board Firmware Download & Debug Tool for Telink TLSR82xx Wireless SoCs

The TLSRGSOCBK56B is Telink's official burning board the compact "black box" programmer that sits between your PC and a Telink wireless SoC to download firmware and run debug sessions. If you are building with Telink's TLSR82xx family the TLSR8258 / 825x BLE 5.0 SoCs found in smart home devices, wearables, wireless sensors and mesh lighting this is the programming tool the Telink ecosystem is built around, the same board included in Telink's TLSR8258 mesh starter kits.

Simple to wire, clear to operate. The board connects to your PC over USB (cable included) and to the target chip over Telink's SWS single-wire debug interface. The clearly labeled pin header provides everything a Telink target needs SWS data, UART (UTX/URX), reference and supply rails (3V3 / 1V5 / 5V), VPP and eFS lines [verify pin functions] so connecting a bare module or an EVK takes just a few dupont wires. On-board RST / SW1 / SW2 buttons handle reset and boot-mode control, while four status LEDs give immediate visual feedback on power and burning status.

Part of a complete toolchain. Use it with Telink's official burning and debug tools to flash firmware images, verify chips on a production line, and iterate during development alongside Telink's SDK and VS Code extension workflow [verify]. From first prototype to small-batch factory programming, one board covers the whole lifecycle.

Typical applications

1. Firmware download / flashing for Telink TLSR82xx SoCs (TLSR8258, 825x and related series [verify full list])
2. Debugging during firmware development
3. Production-line programming and chip verification
4. Lab / EVK use with Telink starter kits and modules