2in1 AHD 1080P Trajectory License Plate Backup Camera for Car, Truck, SUV, Minivan, Camper, RV, Pickup, GreenYi Rear View License Plate Frame Camera

AHD 1080P High Definition Backup Camera---1054 sensor chip, 1920*1080 Pixels, 0.01 flux to support high quality night vision image, 170 degrees viewing angle, no worry about blind spot area, IP68 waterproof, works properly under car washing or bad weather, fantastic night vision effect, can be used on Truck, SUV, Minivan, Camper, RV, Pickup and so on. ^^ Back Up Camera With Movable Guideline---Applying new chip, our back up camera can show trajectory guide line without extra device, its guide line automatically changes according to the cars moving direction.

^^ CAN ONLY BE USED AS REAR VIEW Camera & Different Installation Methods For Your Choice---This license plate camera is with guideline and shows mirror image used as reverse camera by default. There maybe two guide lines shown on your head unit, please change the setting of your device to turn off the original one. For our license plate camera, you can install it behind of the license plate, or you may apply the mini bracket and install it above the license plate. ^^ Dynamic Trajectory Guide Line Rearview Camera with Switcher Cables--- It generates CVBS 30HZ/30FPS/NTSC video signal by default.

Cut the green wire to make the camera generate AHD-1080P-25HZ/25FPS/PAL video signal. Cut the white wire to make the camera generate AHD-720P-25HZ/25FPS/PAL video signal. Cut both switcher cables to make the camera generate CVBS 30HZ/30FPS/NTSC video signal.
NOTE: Please unplug and reconnect the 4-pin power cable after cutting any wire. ^^ IP68 Rated Waterproof Reverse Camera---When manufacturing the reversing camera, we have tried our best to upgrade the waterproof grade. We have fulfilled the whole camera body with waterproof silicon rubber, we tested every single camera under water for 24 hours, it will work properly under extreme conditions. ^^ Backing Camera Work With Monitors Supports RCA Connection---This backing up camera only works with monitors which supports RCA connection. For normal mirror monitors or TFT monitors, no need to use the trigger detection cable. When it works with a radio head unit, please remember to connect the trigger wire.
^^ ATTENTION: Anything unclear, please check the user manual in the package or leave a message on, we will get back within 24 hours usually