Mount-It! Dual Arm Monitor and Laptop Mount for Desk, Fits 27 In and 17 In

A monitor and a laptop on the same desk end up crowding each other out. The Mount-It! Dual Arm Monitor and Laptop Mount puts each on its own arm, from one base, so both screens sit where you can see them and the desktop stays open. It clamps or grommets to the desk and is designed for one monitor and one laptop. The monitor arm fits screens from 13 to 27 inches with VESA 75x75 and 100x100 patterns. To confirm yours, measure center to center between the four mounting holes on the back of the monitor, horizontally and then vertically, in millimeters.

The laptop arm carries an 11.75 x 11 inch ventilated tray for laptops up to 17 inches, with side holders that open from 9.5 to 16.5 inches, traction pads, and locking buckles. Each arm holds up to 13.2 lbs, so weigh your monitor and laptop before ordering. Each arm raises, lowers, and
extends on its own: the monitor arm adjusts from 9 to 18.75 inches in height and reaches 15.5 to 19 inches, and the laptop arm reaches 10.5 to 23.5 inches. The monitor head tilts 180 degrees, the laptop tray tilts 135 degrees, and the arms swivel 360 degrees at the base and elbow and 180 degrees at each head. A hex key sets the spring tension. The tray positions a screen and is not meant as a typing surface, so use an external keyboard and mouse. Cable management keeps cords routed along the arms. Choose the included
C-clamp or grommet base: the clamp fits desks 0.5 to 3.5 inches thick, and the grommet base mounts through a 10 to 50 mm hole. Setup goes in stages. Two people handle the first step, because one holds the spring arm halves together while the other cuts the cable tie and the arm is slowly released. Then secure the base, attach the monitor with the included M4 or M5 screws and washers, and fit the side holders onto the tray and screw the tray to the laptop arm.
Set the spring tension last: with the screens mounted, hold each arm level and turn the tension screw with the hex key until it stays level, counter-clockwise if it drops and clockwise if it rises, without over tightening. All parts and tools needed for assembly come in the box. Mount-It! backs this monitor and laptop mount with a lifetime manufacturer warranty and US-based product specialists available during standard business hours.