A2 PC USB Programming Cable Siemens Simatic S7-200 PLC S7-300 PLC S7-400 PLC Replaces 6ES7 972-0CB20-0XA0 Compatible Step7 MPI PC Adapter USB

Description:
1. Support the Siemens S7-200 / 300/400 PLC communications.
2. The signal partially isolated by high-speed optical coupling.
3. Support for MPI and DP multi-master communication, support Siemens touch screen.
4. Support for multi-master communication 200PLC and ET200 communications, and PPI.
5. Support 840D CNC system programming.
6. The installation of Siemens original driver, without generating serial, USB direct selection
7. Support WIN7 32 and 64 series, support V 5.5 software (no need to install the drive in V 5.5 )
8. There are soft shell protection, anti-pressure, drop.
9. The choice of PTC resettable fuse, overvoltage, overcurrent, short circuit case well protected internal circuitry.
10. Support a variety of high-end communication Siemens PLC

Specification:
1. Support 0CB20 eight generations of operating systems: Windows2000/ Win 2003 / Windows XP / Vista / windows 7 32bit / 64 bit
2. Support 0CB20 eight generations of programming software version: STEP7 V 5.2 and higher, STEP7 Micro / Win 4.0 and above
3. Full-speed USB device interface, compatible with USB V 2.0 specification
4.
Power: USB bus powered, power consumption of about 100mA, with overcurrent protection and surge protection
5.
Optical Isolation voltage: 1000VDC
6. USB port with anti-surge protection
7. Support for
MPI baud rate: 19.2K bps, 187.5K bps automatically adapt
8.
Support PPI baud: 9.6K bps, 19.2K bps, 187.5K bps automatically adapt
9. Support for long-distance communications, the maximum communication distance of 1000 m (RS485 end, when the baud rate is 187.5K bps)
10. LEDs with power, data reception indicator, the data transmission indicator
11. Each PC only supports a programming cable 0CB20 Yashiro
12.
Working temperature: -20 ~ + 75
13.
Cable length: 5 m

Package Included:
1 x Box
1 x 5m Electric Cable
1 x Interface Cable