HTLNUZD Mateksys H7A3-WING Flight Controller MicroSD Datalogging, Built-in OSD 3-8S LiPo for RC Multirotor, Fixed-Wing FPV Aircraft

Specifications

MCU: STM32H7A3RIT6, 280MHz Cortex-M7, 1.4MB RAM, 2MB
Flash IMU: ICM42688P
Baro: SPL06-001
OSD: AT7456E
Blackbox: MicroSD socket I2C digital power monitor 6x Uarts (1, 2, 3, 4, 5, 6) with built-in inversion. 11x PWM outputs 1x I2C 1x CAN 4x ADC (VBAT, Current, VB2, Cur2) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator (Red) USB/Beep Extender with Type-C(USB 2.0 ) 2x JST-GH 1.25 _4pin connector for CAN and I2C 9V/12V output ON/OFF switchable Digital video OSD is supported by any spare
UART Regulators Vbat Input: 9~30V (3~6S LiPo) BEC 5V/4v 5: 2. 5A cont.
/3A peak BEC 9V/12V: 2A cont.
/3A peak BEC Vx: 8A cont. /12A Peak, output 5V Default, 6V or 7.2V option.
LDO 3.3V: Max. 200mA I2C digital power monitor No calibration required.
Current sensing resistor: 0.00025 ohm Load current on current sensing resistor: 100A (Continuous), 164A (Burst)
Voltage accuracy: ± 0.1 %
Current accuracy: ± 2%
INA2xx I2C address: 0x45 (69) Parameters BATT_MONITOR ->21 (INA2xx) BATT_SHUNT -> 0.00025 BATT_MAX_AMPS -> 164 BATT_I2C_BUS -> 0 default BATT_I2C_ADDR -> 0 default (or 69)
FC Firmware ArduPilot: MATEKH7A3 ( 4.6 or newer)
Physical Mounting: 30.5 x 30.5 mm, 4mm with Grommets 3mm
Dimensions: 54 x 36 x 13 mm
Weight: 30g with USB extender Including 1x H7A3-WING 1x USB(Type-C)/Beep (Passive buzzer) Extender with 6pin cable 1x 20cm JST-SH-6P to JST-SH-6P cable for USB extender. 2x 20cm JST-GH-4P to JST-GH-4P cable for CAN & I2C port 1x Rubycon ZLH 35V 470uF capacitor Dupont 2.54 pins (Board is shipped unsoldered)