Meet Your Seller
AJMRTC 2Pcs PCF8574 PCF8574T I2C I/O Expansion Board, 8-Bit GPIO Expander Breakout Module with Interrupt Pin for Arduino Raspberry Pi STM32 Electronic Development
- 1. Built with PCF8574T chip, expands extra 8 quasi-bidirectional GPIO pins via I2C bus
- 2. 3 address selection pins, up to 8 modules cascaded on one I2C bus for 64 I/O total
- 3. Open-drain interrupt output pin, notify MCU of input state change without continuous polling
- 4. Wide 2.5V-6V working voltage, compatible with both 3.3V and 5V microcontroller systems
- 5. Pre-soldered pin header, easy wiring, great for LED, relay, button and sensor control projects
Any questions? Ask CelesteSM will help you find out quickly.
AJMRTC PCF8574 I2C IO expander breakout module is a practical solution when your microcontroller runs out of native GPIO pins. The PCF8574T chip converts the I2C serial signal into 8 independent quasi-bidirectional digital I/O ports. Each pin can be configured as input or output flexibly and features latch output with strong drive capacity to directly light LEDs or trigger low-power switches. It reserves A0, A1, A2 address jumpers, allowing you to set unique I2C addresses from 0x20 to 0x27, so you can stack up to 8 modules on the same SDA/SCL bus to get maximum 64 extended IO ports. The onboard INT interrupt pin sends a trigger signal once input status changes, which saves MCU resources compared with constant polling. This module supports 2.5V to 6V power supply and works smoothly with Arduino, Raspberry Pi, ESP32, ESP8266, STM32 and other mainstream development boards. It is widely used for button matrix reading, LED array driving, relay module expansion, IoT sensor acquisition and electronic teaching experiments. Two boards are included in one pack to meet your multiple channel expansion and prototype backup demands.
Specifications
Brand: AJMRTC
Chip Model: PCF8574T
Communication Interface: I2C (IIC)
Extended I/O Quantity: 8-bit Quasi-Bidirectional GPIO
I2C Address Range: 0x20 ~ 0x27, configurable via A0/A1/A2
Interrupt Pin: Open-Drain INT Output
Working Voltage: 2.5V ~ 6V
Logic Compatibility: 3.3V / 5V System
Max I2C Clock: 100kHz
Continuous Sink Current Per Pin: 25mA
Operating Temperature: -40 ~ +85
Included Quantity: 2 Pcs
Application: Arduino, Raspberry Pi, STM32, ESP32, LED & Relay Control, Button Matrix, Electronic DIY Experiment
Mounting: Pre-soldered Pin Header, Breadboard Friendly
Warranty & Returns
Warranty, Returns, And Additional Information
Warranty
- Please contact the Seller directly for warranty information. Warranty information may also be found on the Manufacturer's website.
- CONTACT
Return Policies
- Return for refund within: 30 days
- Return for replacement within: non-replaceable
- This item is covered by ConnectFlow USA Return Policy
Manufacturer Contact Info
- For a directory of all our manufacturers, please click below.
- Manufacturers Directory









