RP2350-LCD-0.96 Development Board, with 0.96inch Display, 160×80 Resolution, Based On RP2350A Dual-core & Dual-Architecture Microcontroller, with Pre-soldered Header

RP2350-LCD- 0.96 is a low-cost, high-performance Pico-like MCU board with flexible digital interfaces. It incorporates Raspberry Pi's RP2350A microcontroller chip, the same as the one on Raspberry Pi Pico 2. For software development, either Raspberry Pi's C/C++ SDK, or the MicroPython is available, which makes it easy for you to get started, and integrate it into end products quickly.

RP2350A microcontroller chip designed by Raspberry Pi in the United Kingdom. Adopts unique dual-core and dual-architecture design: dual-core Arm Cortex-M33 processor and dual-core Hazard 3 RISC-V processor, flexible clock running up to 150 MHz

520KB of SRAM, and 4MB of on-board Flash memory. USB-C connector, keeps it up to date, easier to use. 0.96 inch 160×80 pixels 65K colorful IPS LCD display. Lithium battery recharge/discharge header, suitable for mobile devices

Onboard DC-DC chip MP28164, high efficiency DC. DC buck-boost chip, maximum 2A load current. Castellated module allows soldering directly to carrier boards. USB 1.1 with device and host support Low-power sleep and dormant modes

Drag-and-drop programming using mass storage over USB. 26 × multi-function GPIO pins. 2 × SPI, 2 × I2C, 2 × UART, 4 × 12-bit ADC, 16 × controllable PWM channels

Rich WiKi Resources: We provide official Wiki resources, please contact us for more information.