Question 1

How many fans are included?

Accepted Answer

Only 2 came with mine but that shouldn't deter you from getting this case. It's amazing and I'm really happy with it. Plus fans are pretty cheap nowadays.

Question 2

Does this case come with any fans? If so how many?

Accepted Answer

It comes with one fan, in the back. It has room for two 120mm fans in the front, two in the top, and one on the bottom (if your PSU is small enough.

This case does not have room in the top or front for a radiator, so water cooling really isn't possible. The only way I can see to water cool is by getting a very small radiator and replacing the back fan with it.

Question 3

Can you take away the "IN WIN" that is in the window, so that you have a clear window (or wish to apply your own window sticker)?

Accepted Answer

don't own this any longer. it appeared to be painted on, but don't know of a solvent that would remove it without damaging the plastic. my advice: DO NOT BUY THIS. the connections and top/front controls are substandard, and not well thought-out for ease of access or checking for loose connections, replacing or repair.

Question 4

so hown many fans do i need to buy?

Accepted Answer

That depends on you..  
It comes with 1 intake in front of were the drives go and 1 in the rear the exaust  a total 2...
It has an opening to put 1 more 120 mm in front 1 on the bottom and 2 on the top so its all up to you really ...  probably 1 more 120mm for the front would be enough to get good airflow through the case....  
Good Luck with your build

Question 5

Can a EVGA GeForce GTX 950 SSC GAMING ACX 2.0 fit into this case? It is a fairly large graphics card, at 10.1 inches long, and 4.376 inches height. (I don't think it matters, but it is a dual slot graphics card)

Accepted Answer

I have the GTX 760, and the dimensions for that are 9.5" x 4.38"
It fits pretty well, probably at most 2 inches to spare in lengh before it bumps into the HDD trays and as far as height with the coil cord it's just about a perfect fit, although the cover to it does kind of press against the cord, but that's only because they are so thick and don't bend easily out of direction, but the height of mine is 4.380 it seems and yours is 4.376, probably not much of a difference but it should be about the same, this is an awesome looking case too, although it is really big, but if that's not a problem for you I'd say it would be fine. One small minor thing I can remember though is that the front panel USB 3.0 needed an extension because the one it came with was too short to reach the motherboard, I don't know if they are all like that or if it was just in my situation, anyway Good Luck!

Question 6

Will the Thermaltake Water 3.0 Ultimate CPU Cooler fit in this?

Accepted Answer

not without modification. The top has room for 2 120 fans under the plastic and that is about it. You could mod the case to fit a 240 rad but that particular water cooler will not fit without some cutting.

Question 7

Are you supposed to hook the fans directly to the case fan controller or does it need to be hooked up to the motherboard and the fan controller? Or just the motherboard?

Accepted Answer

I would personnally use the Motherboard connections so the Motherboard and its Software or BIOs will regulate the Fans by need and Parameters.If you want to use the Controller for certain fans...plug the Top Fan and possibly 1 front Fan if it has 2...hope this helps...

Question 8

will a gtx 1070 g1 gaming edition fit in this case?

Accepted Answer

Yes. The GT1 has a removable sideboard on the hard drive bay that will allow you to use any card up to 408mm (16.1") long. The Gigabyte GTX 1070 G1 Gaming is 280mm (11.02") long and should fit without removing the sideboard.

Question 9

Will the DEEPCOOL Gamer Storm CAPTAIN 240 or 120 fit in this case?

Accepted Answer

I know the 120 would fit but not to sure on the 240 because i measured the top of it and its 228mm and the 240 is like 274mm. It might work because the fans are above where the metal is and might clear it. This case can have two 120mm fans on the top. If not you could cut the metal a little and work just fine and you wouldn't even see it.

Question 10

How many fans does this come with??

Accepted Answer

the red one you see in the back. there are mounting areas for at least 2 more you-buy-it fans.

Material	SECC Steel
External Drive Bays	5.25" x 3
Internal Drive Bays	3.5" / 2.5" x 6 (Supports up to SATA HDD EZ-Swap Module x 4), 2.5" x 2
MB Form Factor	ATX, m-ATX
Power Supply	ATX 12V, PSII Size
Top Port	Fan Speed Controller 3.5"/2.5" SATA HDD EZ-Swap x 1
Front Port	USB 3.0 x 1 (Internal Connector) USB 2.0 x 2 HD Audio
I/O Expansion Slots	PCI-E Slot x 7 (Supports up to 408mm)
Thermal Solution	Supports up to Total 120mm Fan x 8 (Different regions may carry different specification) Front - Supports 120mm Fan x 1 (Supports 120mm Fan x 2 max.) Rear - Supports 120mm Red LED Fan x 1 Side - Supports up to 120mm Fan x 2 (Mesh side panel only) Top - Supports up to 120mm Fan x 2 Bottom - Supports up to 120mm Fan x 1 Water-Cooling Ready
Dimensions (H x W x D)	18.7 x 8.3 x 19.3" (475 x 210 x 491mm)

Type	ATX Mid Tower
Color	Black
Case Material	SECC Steel
With Power Supply	No
Power Supply Mounted	Bottom
Motherboard Compatibility	Micro ATX / ATX
Side Panel Window	Yes
Dust Filters	Yes

External 5.25" Drive Bays	3
External 3.5" Drive Bays	No
Internal 3.5" Drive Bays	6
Internal 2.5" Drive Bays	2
Hot-Swap Drive Bays	1
Expansion Slots	7

Dimensions	18.7" x 8.3" x 19.3"
Weight	15

IN WIN GT1 Black SECC Steel ATX Mid Tower Computer Case

Specifications

Learn more about the In Win GT1

Customer Reviews of the In Win GT1

Warranty & Returns

Warranty, Returns, And Additional Information

Warranty

Return Policies

Manufacturer Contact Info

Model
Brand	IN WIN
Model	GT1

Item#: N82E16811108433