Question 1

how loud will this be with all fans running on high?

Accepted Answer

Before I answer, I want to mention that only the 2 top fans are connected to the low/med/high switch. I have mine on high & I can't hear them at all. Even when it's totally quiet in my room, I can still barely hear any of them running.

Question 2

Some people are saying the fans connect via 4 pin is this true? Are all the fans powered this way,or are they powered by the standard Molex connectors?

Accepted Answer

All the 5 fans have the standard 3pin connector to motherboard header (no PWM control) spliced to a molex connector, meaning you can use either method to connect any of the fans. The fan controller can control 2 fans for sure, don't remember if it can control 3, and the connection to the fan controller is through molex.

Question 3

does this case have red LED lighting?

Accepted Answer

Yes and No.

No because the case itself doesn't have Red LED Lighting, but the fans pre-installed in the front of the case are clear white (when turned off), but when turned on they shine a deep red.

Question 4

How well will these fans move air? I don't want to spend extra on other fans.

Accepted Answer

trustme, there is more fans then you will need. it has two on top one on back and 2 in front. Top and front ones are very effective. Plus you power supply has a fan, and your cpu cooler has one. If you add a video card with a fan too, you will have a total of 8 fans, which is more then enough. There is a fan speed controller for the top two fans. The options are off, low, and high. I use low and it is more then i need.

Question 5

How many fans do I need to connect to the motherboard? Or are they all already connected?

Accepted Answer

The top two fans are connected to the fan speed switch on the front panel and thus need only a power connection.  That leaves the back fan and the two front fans.  In my case, I hooked the back fan up to one motherboard connection and then used a y-cable to connect the two front fans to a second motherboard connection.

So in total, I used 2 motherboard connections and one direct power connection.

Question 6

How much space is there behind the motherboard tray for cable management?

Accepted Answer

There is 3/8" on the back panel or cover for cable management.

Question 7

A review stated there're 3 fan speed Low, Medium and High.  I can only set it to Low and High, when I switch to the middle the two top  fans stop spinning.  They're connected via Molex.  Is my case defective ?

Thanks

Accepted Answer

Their website concerning this product  says "With one fan-speed adjusting switch, can control 2 fans at the same time"
That is really vague, but all I can find.
Mine does the same thing, but I always leave my fan switch on high . . . .leaning on the side of deaf so sound/noise is not an issue!

Question 8

is the case made out of metal or plastic??

Accepted Answer

The sides of the case as well as the main frame on the bottom are made of a very thin metal, the top is a single piece of plastic that covers the fan housing.  The front panels are also made of plastic.  If you do buy this case and need to move it, I suggest picking it up from the bottom and not using the top as a grip for anything, as the single piece comes off very easily.

Question 9

What are the rpm s of the fans?

Accepted Answer

Thanks john been looking at others where I cold install coolmaster 120mmm my self twice the speed half the sound 69 cfm and 19 decibells and light red led accents. stll might do that with this case. I use gtx 970 strix and a i7 4690k overclocked to 4.3 using 1.114 volts with Artic cooler 7 rev 2 73c version 266
prime 95 do to avx issue ambiant temp 24c not bad in open case, but in a close you case see my concern.Considering coolmaster evo but don't want to loose top pci-e slot for sound card.

Thanks again,your information helped

Question 10

would a EVGA 600B 600W 80+ Bronze Certified ATX Power Supply fit in this case?

Accepted Answer

I believe there would be adequate room for your power supply. I put a evga 750 in mine

Brand	Deepcool
Model	KENDOMEN Red

Type	ATX Mid Tower
Color	Red
Case Material	SECC + Plastic (ABS) (Panel Thickness: 0.7mm)
With Power Supply	No
Power Supply	ATX PS2 (not included)
Motherboard Compatibility	Micro ATX / ATX / Mini-ITX
Side Panel	with Side Window
Dust Filters	Front / bottom panel with removable filters

External 5.25" Drive Bays	3 (all tool-free installation)
Internal 3.5" Drive Bays	3 (all tool-free installation)
Internal 2.5" Drive Bays	3 (tool-free) + 3 (Switchable from 3.5")
Expansion Slots	7

Max GPU Length	310 mm
Max CPU Cooler Height	160 mm
Dimensions	19.13" x 7.87" x 19.33"
Weight	12.70 lbs.

DEEPCOOL KENDOMEN Red ATX Mid Tower Computer Case Pre-installed 5 Cooling Fans With Side Window Support 240mm Water Cooling Installation at Top

DEEPCOOL KENDOMEN ATX Mid Tower

Features

Excellent Cooling Performance

Easy Installation

Superior Expandability

Easy Future Maintaining

Connection and Controlling

Gallery

Learn more about the DEEPCOOL KENDOMEN Red

Customer Reviews of the DEEPCOOL KENDOMEN Red

Warranty & Returns

Warranty, Returns, And Additional Information

Warranty

Return Policies

Manufacturer Contact Info

Item#: N82E16811853013