Specifications: ATX PSU each output connectors check
Tests 20-pin and 24-pin power supplies
Tests SATA power
Tests Pentium 4 power connector
Tests PCI-Express power connectors
Tests Xeon power connectors
Tests Floppy drive connectors
Tests standard 4-pin power supply connectors
Accurate voltage indicator +/-V(+12V1/+5V/+3.3V/5VSB/+12V2/ -12V)
ATX P.G value display.
Lower or higher P.G values alarm
Lower voltage detected alarm.
Over voltage alarm.
No voltage detected alarm.
Dimension : 2.52" x 5.91" x 0.71"
Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board.
Just peel and stick.
Reduce the risk of hardware failure due to overheating.
Installation Instructions:
Make sure the chip modules are free from dirt and grease.
Peel the protective liner off on the base of the heatsink.
Apply the heatsinks to the corresponding chip modules and apply firm pressure.
Package Includes:
1x 14mmx14mmx7.5mm Aluminum Heatsink for Raspberry pi 2B CPU chipset
1x 8.8mmx8.8mmx5mm Aluminum Heatsink for Raspberry pi 2B LAN chipset
Dimensions: 1x 14mmx14mmx7.5mm CPU chipset
1x 8.8mmx8.8mmx5mm LAN chipset
Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board.
These heat sinks have profiles which are short enough to fit within standard Raspberry Pi cases.
Pure copper heatsink thermal conductivity up to 401w / mk,good idear for processor,CPU and GPU cooling,Tested to fit the Raspberry Pi CPU / SoC,reduce the risk of hardware failure due to overheating.
These heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips.
These heat sinks can be used with other devices such as the Beaglebone to cool processor, regulators, etc.
Installation Instructions:
-Make sure the chip modules are free from dirt and gre...