Features: 10 pcs of 8.8x8.8x5mm aluminum heat sinks with 3M 8810 Heat transfer Peel and Stick Tape
Widely use for 3D Printer A4988 chipset,computer PC chipset, power IC, power electric device, LED light devices,Raspberry Pi,Banan Pi, Orange Pi,etc.
Come with 3M 8810, is a tacky pressure sensitive adhesive loaded with thermally conductive ceramic fillers that do not require a heat cure cycle to form an excellent bond to many substrates. Only pressure is needed to form an excellent bond and thermal interface.
The specialized chemistry of 3M 8810 renders the tape modestly soft and able to wet to many surfaces, allowing it to conform well to non-flat substrates, provide high adhesion, and act as a good thermal interface
Excellent adhesive performance with good wetting and flow onto many substrate surfaces....
Features: Aluminum Heat-Sink, For Package TO-220 / L7805 /LM337 Triode Transistors Cooler IC Chipset
Quantity: a lot of 20 Pieces
M3 Screw Hole.
Size: 19x 15x 10mm/ 0.8" x 0.6" x 0.4" (L*W*H)
Thickness" 0.8mm
Color : Anodized Black
Weight: 2g/ piece
Please check the specification table and make sure that the size of the heatsink fits that of your component
Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board.
Just peel and stick.
Reduce the risk of hardware failure due to overheating.
Installation Instructions:
Make sure the chip modules are free from dirt and grease.
Peel the protective liner off on the base of the heatsink.
Apply the heatsinks to the corresponding chip modules and apply firm pressure.
Package Includes:
1x 14mmx14mmx7.5mm Aluminum Heatsink for Raspberry pi 2B CPU chipset
1x 8.8mmx8.8mmx5mm Aluminum Heatsink for Raspberry pi 2B LAN chipset
Dimensions: 1x 14mmx14mmx7.5mm CPU chipset
1x 8.8mmx8.8mmx5mm LAN chipset
Features: This Copper Shims thermal conductivity up to 401w / mk, and ordinary copper thermal conductivity is only 20-30w / mk
CPU and GPU graphics card in the inside part of the laptop using a thermal plastic thermal conductivity, thermal plastic at high temperature for a long time easy to aging, and ultimately lost, leading to overheating of the CPU or GPU, the Laptop will not start after overheating.
With this copper pad to greatly lower gpu temperatures, can be used for graphics, northbridge, CPU chips.
It can be used as heatsink solution for Xbox ,PS4 and all laptop and computer such as HP,Dell,Acer,Thinkpad etc.
Package included:
10 pcs Thermal Conductive Copper Shims 20mm x 20mm x 0.5mm
Features: Anodized Black Aluminum heatsink for Computer General northbridge ,Southbridge Cooling ,also can be used for cooling graphics card, vidoe card,motherboard, power transistor, FET, IC, power amplifier, Voltage Regulator,etc.
The fins increase the area of the board and thus provide for greater heat transfer.
Use heatsink adhesive glue to install heatsink on the IC.Glue is not included here.
Size is 28mm x 28mm x 20mm low profile , Please check the specification table and make sure that the size of the heatsink fits that of your component.
Specification
Product Name: Heatsink
Material: Aluminium
Color: Anodized Black
Overall Size: 28 x 28 x 20mm/ 1.1" x 1.1" x 0.8" (L*W*H)
Weight: 30g
Package Content: 2pcs x Heatsink