XH-M594 Battery Charging Control Module Battery Anti-overshoot Protection Board 8-120V

Introduction:

This product is suitable for charging safety protection of various batteries and lithium batteries; it can effectively protect the battery from overcharging during the charging process, thereby affecting the service life of the battery. It is a barrier to battery safety.

Parameter:

Product name: Battery charging protection module

Product model: XH-M594

Power supply voltage: DC8-120V

Control voltage: DC8-120V

Control accuracy: 0.1V

Product power consumption: <2W

Scope of application: battery, lithium battery

Product net weight: 80g

Product size: 79*55*19mm

Settings:

1. Connect the XH-M594 module to the charger and battery, and pay attention to the positive and negative terminals of the Zengchu that are marked with "+"-" symbols;

2. The voltage will be displayed on the screen after power-on. When the battery is not connected, the voltage will display as 0 because there is no current.

3. Mainboard power supply selection switch, you can switch the current power supply selection module of the XH-M594 module, and you can use the charger GHG or battery power supply BAT

4. Long press the'+, key to set the starting voltage, (short press to display the starting voltage) then the starting voltage will flash, then you can press the'+''-, key to set the voltage you want. After setting, wait 5 seconds, the system will automatically save.

5. Long press the'-' button to set the stop voltage, (short press to display the stop voltage) at this time, the stop will flash, then you can press the'+''-, button to set the voltage you want. After setting, wait for 5 seconds, the system will automatically save.