Upgeaded DA63-06542A Refrigerator Door Gasket Replacement for Samsung Refrigerator French Door Seal, 39.57"x16.93" Refrigerator Seal Replace Part DA97-07191A, 2813286, AP5323696 Fridge Door Gasket

The DA63-06542A refrigerator seal has an approximate size of 39.57" x 16.93". Please measure your old gasket carefully before purchase. This DA63-06542A gasket is intended for the left and right side door. It fits various Samsung appliance models; please verify this part is correct for your specific model before ordering. Many door gaskets appear similar but are not identical in size, so please order based on dimensions rather than appearance. This durability-enhanced refrigerator gasket replacement (Model
DA63-06542A) addresses common issues: Broken, torn, or worn door gasket; Moldy and dirty door gasket; Leaking or poor seal, causing temperature fluctuations; Internal condensation, frost, or ice accumulation. This is a brand-new, genuine refrigerator door gasket, engineered to restore the door seal and block warm air entry. This DA63-06542A fridge door gasket replaces multiple part numbers, such as DA97-07191A, 2813286, AP5323696, PS4151582, and EAP4151582.
Note: To smooth folds and creases in gasket DA63-06542A, soak it in warm water or gently warm it with a hair dryer on a low setting. This DA63-06542A refrigerator door gasket is compatible with Samsung refrigerator models including RF260BEAESR/AA-01, RF261BEAESP/AA-06, RF262BEAESR/AA, RF263AEWP/XAA, RF263BEAEWW/AA-05, RF263TEAESR/AA-04, RF266AEWP/XAA, RF267AEPN/XAA, RF268ACPN/XAA, RF268ACRS/XAA, RF26HFENDSR/AA-04, RF26XAEPN/XAA, RF26XAERS/XAA, RF26XAERS/XAA-00, RF26XAEWP/XAA, and others. This refrigerator door seal is constructed from premium, flexible materials. The black door gasket provides a secure seal, enhancing energy efficiency and preserving optimal cooling. To install, easily remove the old door seal gaskets by hand and fit the new ones. Use a screwdriver to remove the two screws securing the door guard on the left-side door. The gasket attaches easily to the door fitting.
To remove kinks: 1. Fill a tub with hot water and submerge the gasket for up to 30 minutes. 2. Use a hair dryer to warm the rubber, or place the gasket in a clothes dryer for 10 minutes. Heat is essential for removing kinks without damaging the gasket. 3. Place the treated gasket on a table and gently stretch the rubber into the required shape for the freezer door, such as square or rectangular. Let it lie flat until installation. If the refrigerator or freezer door gasket is not sealing: 1. Direct a hair dryer on hot air at the air bag layer in the seal's center until the seal lies flat against the refrigerator. 2. If the door seal lacks strong magnetic properties, apply some vegetable oil on a paper towel and rub it on the seal near the door hinge from top to bottom, then close the door. 3. Apply a thin layer of petroleum jelly along the sealing surface of the door gasket to aid proper sealing. 4. Close the door and inspect the fit. The door gasket should fit snugly against the cabinet and door with no visible gaps. Then secure it with tape for 12 hours