OBD2 to USB C Power Cable for Dash Cam, Plug and Play Dashcam Hardwire Kit with LED Voltmeter, 4-Level Low Voltage Protection (11.6V/11.9V/12.5V/20min), 12V-24V to 5V/3A for Parking Mode, 11.5ft/3.5M

Note for 20-Minute
Timer Mode: Power is disconnected 20 minutes after the vehicle is turned off and comes to a complete stop. If this function does not operate on your vehicle, please
verify the following:
1. Check whether your dashcam supports time-lapse parking recording.
2. Ensure the vehicle is fully stationary (and that no one is inside).
3. The ACC solder leg follows A5-B5 signal pins (confirm with your dash cam seller). The USB Type-C connector of this OBD II power cable utilizes A5-B5 signal pins and may not be compatible with some dash cam brands that use A8-B8 signal pins. Smart 4-Level
Adjustable Voltage Protection: Low voltage protection, featuring a built-in sensitive power management chip that provides selectable low-voltage cutoffs ( 11.6V / 11.9V / 12.5V /20min), to avoid car battery drainage. The intelligent circuit automatically cuts off power when the voltage falls to the preset level, preserving sufficient power to start the engine. 24/7 Parking Monitoring & ACC Auto Switch Mode: Automatically supplies power to the dashcam when starting the vehicle (ACC mode), and offers all-weather monitoring when parked, enabling continuous recording, parking mode, and timelapse recording by delivering constant power. Built-in low voltage protection prevents car-battery drain. Plug and Play OBD2 To
USB C: Plug and play OBD2 to USB-C power cable compatible with any dashcam. Connect the dashcam cable harness to the USB C interface of the car. The power cord can be installed easily and is a good option for concealed installation. High-Security Hardwire Kit for
Dash Cam: This dashcam hard-wiring kit includes a built-in fuse and multiple protective features (over-current, short-circuit, over-heat, and reverse connection) to protect both your dashcam and your vehicle. Wide Compatibility & Stable
Power Supply:
Input: 12V-24V vehicle voltage to a stable 5V/3A Output, for most USB-C dash cams, GPS units, and radar detectors on cars, trucks, SUVs, and commercial vehicles.
Real-Time LED Voltage Display: The power cord features a built-in high-definition LED screen that shows the car battery's voltage in real time. The OBD2 to USB C power cable kit is 3.5 meters long and contains 1 pry tool and 4 wire ties for your installation requirements