OBD2 to USB C Power Cable for Dash Cam, Plug and Play Dashcam Hardwire Kit with LED Voltmeter, 4-Level Low Voltage Protection (11.6V/11.9V/12.5V/20min), 12V-24V to 5V/3A for Parking Mode, 11.5ft/3.5M

**Note for 20-Minute Timer Mode** Power supply is cut off 20 minutes after the vehicle is turned off and comes to a stop. If this feature does not function on your vehicle, please
verify the following: 1. Check if your dash cam supports time-lapse parking recording. 2. Ensure the vehicle is completely stationary (with no one inside). 3. The ACC solder leg follows A5-B5 signal pins. The USB Type-C connector of this OBD II power cable utilizes A5-B5 signal pins and may not be compatible with some dash cam brands that use A8-B8 signal pins. **Smart 4-Level Adjustable Voltage Protection** Features low voltage protection. The built-in sensitive power management chip provides selectable low-voltage cutoffs ( 11.6V, 11.9V, 12.5V, 20min) to prevent car battery drainage. The intelligent circuit automatically cuts off power when the voltage drops to the set level, leaving sufficient power to start the engine. **24/7 Parking Monitoring & ACC Auto Switch Mode** Automatically powers the dash cam when starting the vehicle (ACC mode), and provides all-weather monitoring when parked. It enables continuous recording and time-lapse recording by supplying constant power. Built-in low voltage protection prevents car-battery drain. **Plug and Play OBD2 To USB C** This plug-and-play OBD2 to USB-C power cable is compatible with most USB-C dash cams, GPS units, and radar detectors on cars, trucks, SUVs, and commercial vehicles.

Simply connect the dash cam cable harness to the USB C interface of the car. The power cord can be installed easily and is a suitable option for concealed installation. **High-Security Hardwire Kit for Dash Cam** This hard-wiring kit comes equipped with a built-in fuse and multiple protective features (over-current, short-circuit, over-heat, and reverse connection) to protect both your dash cam and your vehicle. **Wide Compatible & Stable
Power Supply** Input: 12V-24V vehicle voltage.
Output: a stable 5V/3A. Compatible with most USB-C dash cams, GPS units, and radar detectors on cars, trucks, SUVs, and commercial vehicles. **Real-Time LED Voltage Display** The power cord is equipped with a built-in high-definition LED screen that shows the car battery's voltage in real time. This OBD2 to USB C power cable kit is 3.5 meters long and includes 1 pry tool and 4 wire ties to meet your usage and installation needs